|
| nicanic |
|
||
|
Hi guys,
If i was to replace my cam would i have to get the head shaved even if i'm using that same head again? |
||
| Top | |
||
| jvangent |
|
||
|
there is no need to unless your head needs a good clean up. it will raise compression which might see a very small gain in power... but thats about all.
|
||
| Top | |
||
| SWC |
|
||
|
nicanic wrote: Hi guys, If i was to replace my cam would i have to get the head shaved even if i'm using that same head again? Only if you take the head off, but you don't need to do that with a cam change so you should be OK. |
||
| Top | |
||
| nicanic |
|
||
|
Pretty sure i need a new head seal to though
|
||
| Top | |
||
| phongus |
|
|||
|
nicanic wrote: Pretty sure i need a new head seal to though What makes you think that?
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| TROYMAN |
|
||
|
phongus wrote: nicanic wrote: Pretty sure i need a new head seal to though What makes you think that? i have a feling he may be refering to the rocker cover seal??? |
||
| Top | |
||
| SWC |
|
||
|
Do you mean Rocker Cover Gasket or Head Gasket?
|
||
| Top | |
||
| Shifteh |
|
||
|
lol " Please Refer to qualified machanic"
_________________ Crank Assembly balanced, HV oil pump, ACL Trimetal bearings, "1 extra oil clearance taking to around 0.0650-0.0700 on mains and big ends, Moly rings,, Xr6 Cam, POD ( Possibly oversize injectors), Block, Head, Timing cover, belt idler, Alternator,painted in ford light blue |
||
| Top | |
||
| nicanic |
|
||
|
I mean head gasket, I have a slight oil leak out of each side of the front of the head.
|
||
| Top | |
||
| SWC |
|
||
|
New head gasket and the head will need to be skimmed.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 72 guests |
