how to train keypad have searched (for the last 2 hours) can find how to train au1 but not au2
Wot do i need to serach for to find it or how do i do it
any help?.....Cheers Mark

1. The ignition switch should be in the Off position, with all the doors shut and Unlocked.
2. Turn the ignition key to the ACCESSORY position and within 5 seconds, operates the rear demister switch exactly three times in quick succession. (IE. Press the switch so the Demister light turns on, then off, then back on again.)
3. After the 5 seconds is up, the door locks will change state, to indicate that the BEM has entered keypad learn mode.
NOTE : All existing keypads at this point, have been erased from memory !
4. Press either buttons on the keypad that is to be trained. The door locks will change state twice, to indicate that the keypad has been added to the BEM memory.
5. Follow step 4. for each keypad that is to be added to the BEM memory. A maximum of 4 keypads can be added to the BEM memory. NOTE : You must teach all remote keypads for the Smartsheild module, before proceeding.
6. When you have taught all the remote keypads, turn the ignition to the Off position to leave the learn mode. The door locks will change state to indicate a return to normal mode.
7. Check the function of all buttons on each keypad, to ensure that the keypad has been trained.

Thanks VERY much my eyes were poppin out of my head

It's in the Technical Documents section under AU mate... It is easy to miss things though.