Hey people,

Just wondering if anyone can give me some pointers as to why my high beams aren't working at all.

The globes are fine I tested them today direct from the battery.
Normal lights work, but when I put high beams on I lose the lot.

I don't have my workshop manual on me at the moment so if someone could point out exactly where the relay/fuses are for the high beams that would be great (EBII-ED).

Or if anyone has any other ideas? Any help much appreciated!

Cheers.

Well from what I remember, low beams turn off with high beams on??

The relays are down the side of the engine bay, near the battery, under a black cover... the one closest to the front is your horn relay (should be yellow), and then high beam, low beam, and starter motor from memory.


Cheers

Cheers dima.

I must have swapped the yellow relay with a grey relay at some point.
I swapped them back and I have high beams again.

They both work at the same time too, the low and high beams that is...

ok cool.. I always forget that bit

Good to hear alls good.


Cheers