|
| 1jz jzx90 |
|
||
|
he people my head is getting machind 2moz and after some quik advice on how much to take of the guy said i can take a whole 1mm off but didnt think i could go that far i was think more 50-60 thou of i have and au bottom end and mls headgasket any help is good im not worried bout driveability watsoever
|
||
| Top | |
||
| XRfairmont67 |
|
|||
|
there are markers on the bottom face of the head near the corners, they show the machinist how much he can take off.
ive pulled a head off an ed and it had been machined past these points and was still running fine, besides the head gasket was leaking. machining that far would have bumped up the compression too |
|||
| Top | |
|||
| TROYMAN |
|
||
|
1jz jzx90 wrote: he people my head is getting machind 2moz and after some quik advice on how much to take of the guy said i can take a whole 1mm off but didnt think i could go that far i was think more 50-60 thou of i have and au bottom end and mls headgasket any help is good im not worried bout driveability watsoever 1mm is pretty much 40 thou... |
||
| Top | |
||
| tickford_6 |
|
||
Posts: 6449 Joined: 11th Nov 2004 |
My advice i machine until it's flat and stop. either that or you will end up with timing chain noise.
|
||
| Top | |
||
| 1jz jzx90 |
|
||
|
ill work it out with him with wat does wat
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Facebook [Bot], Google [Bot] and 123 guests |
