|
| 4.9 EF Futura |
|
|||
|
{USERNAME} wrote: from ngk site
Your Vehicle: Ford Falcon EF 4.0L 6 Cyl., Tickford, XR6 Spark Plug Part No. Plug Gap Recommended Plug ZGR6B-11 1.1 might as well spash out and get some new plugs Do yourself a favour and check the preset gap as well. So, so easy for the pre-gap to be disturbed.
_________________ I promise..... I will never die. |
|||
| Top | |
|||
| gros20 |
|
||
|
megger isn'tteh best thing to test leads. order 6 new plugs teh flash ones with 3 electrodes, i check my leads then but they arn't the orginla ones so i think they should be right (there top gun 8.8mm ones)
any one tell me how to test oxy senser? or how to replace it as it can't be 2 much |
||
| Top | |
||
| twr7cx |
|
|||
|
{USERNAME} wrote: any one tell me how to test oxy senser? or how to replace it as it can't be 2 much
about the $100.00 mark... you just unscrew it and disconect the wires at the plug and reverse to fit the new one. |
|||
| Top | |
|||
| gros20 |
|
||
|
ya i had alook been priced $80-$120 but when i was looking under teh hood looks like some of teh spark plug leads wer enot connect corectly u cna see a bit of arcing and white stuff on 2 of them were teh other 4 are clean as a whisle.
have fixed this so would that make adifference. plugs are getting changed this weekend anyway. |
||
| Top | |
||
| john_jay |
|
|||
|
{USERNAME} wrote: You can use a megger to test the resistance of the leads...
My EF xr6 has motorcraft leads... what are the chances they are the original leads?? its done 180000km... My EL Ghia V8 had done 190,000km when I started having bad fuel consumption and poor performance, so I started doing the following: 1. replaced my plugs - did not fix it. 2. cleaned MAF sensor - did not fix it. 3. cleaned ISC valve - did not fix it. 4. checked Oxygen sensor and can't bloody clean anything. 5. replaced air filter - improved a little bit. 6. replaced plug leads and cleaned distributor cap - Alleluia !!!! I used 8.0mm EAGLE leads from PEPS Auto and fuel consumption improved from ~20.5L/100km to ~13.2L/100km. I hope this helps in finding out your problem.
_________________ can't aFORD lately |
|||
| Top | |
|||
| gros20 |
|
||
|
yea it helps
plugs are on teh way maf sensor what is taht and how do i clean it? isc replaced oxy sensor looks like and after market shop so might be fine will do taht as last resort air filer my k&n will be cleaned this weekend i will tong tets my tong leads thsi weeeknd. how do u clean dissy cap? don't ya have to be real carfull that u put the cap on in exactly teh same spot or is it the dissy its self u have to keep it in its place? P.S. my leads are 8.8mm top gun leads. i have acess to a MSD lead making kit so i might give that crack. if nothing else helps |
||
| Top | |
||
| john_jay |
|
|||
|
{USERNAME} wrote: yea it helps
plugs are on teh way maf sensor what is taht and how do i clean it? isc replaced oxy sensor looks like and after market shop so might be fine will do taht as last resort air filer my k&n will be cleaned this weekend i will tong tets my tong leads thsi weeeknd. how do u clean dissy cap? don't ya have to be real carfull that u put the cap on in exactly teh same spot or is it the dissy its self u have to keep it in its place? P.S. my leads are 8.8mm top gun leads. i have acess to a MSD lead making kit so i might give that crack. if nothing else helps I'm not sure if you are using MAF sensor. I have read somewhere in this groups that I6 uses MAP sensor and it might be different. Anyway here are some of the links that will give you an idea of how to clean MAF sensor. {DESCRIPTION} {DESCRIPTION} cleaning distributor cap on V8 is easy but i dont know how it is done on I6. Distributor cap normally has a guide that will allow you to put it back to its original position. Once you removed the cap, inspect all the metal plates and gently clean them up with 1200 grade sand paper. Mine was so dirty that most of the plates had a build up of white carbon. After cleaning mine i immediately felt a big gain in power. with regards to making your own leads, make sure that the resistance is within specs as each of the leads differ in length.
_________________ can't aFORD lately |
|||
| Top | |
|||
| Ashman1985 |
|
||
|
My EF doesn't have a distributor, so it's not that...
I might splash out on a new set of leads... Funny thing, when I replaced a lead a while back (i broke it  ) I counted 7 leads...
They had obviously replaced a lead and left the old one there... |
||
| Top | |
||
| GTBob |
|
|||
|
What model and is it 6cyl or v8, poor milage is too often caused by WRONG THERMOSTATS. what temp doed it run at normally
 
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| richard williams |
|
||
Age: 55 Posts: 535 Joined: 22nd Sep 2005 Ride: EF wagon & EF fairmont wagon & M Location: melbourne |
OXY sensor for sure my consumption dropped from 300klm tank to 400klm lpg
also leads and plugs. you should be able to get oxy sensor for about $60-80 they have a limited life of about 100,000klm |
||
| Top | |
||
| GTBob |
|
|||
|
{USERNAME} wrote: OXY sensor for sure my consumption dropped from 300klm tank to 400klm lpg
also leads and plugs. you should be able to get oxy sensor for about $60-80 they have a limited life of about 100,000klm Not true my oxy sensor has done 200,000 kms and not a fault and one of the limo's that I used to service had done 850,000 kms on the same oxy sensor 
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
| Top | |
|||
| gros20 |
|
||
|
its v6
got oxy sensor for $60 on ebay as for 7 leads did u count them on the disst 6 cylinder and 1 to coil. some one needs to make a sticky on this |
||
| Top | |
||
| phongus |
|
|||
|
u wanted to know where the fuel filter is. well the fuel filter is on the passenger side of the car underneath the rear passenger side door. its not too hard to replace but if u do replace it make sure there arent any leaks after it. had to put some rubber washers in that came with the valvoline fuel filter and stopped the fuel leak i kinda had. hope that helps.
u will need 2 spanners. not sure what size though. good luck phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| russo1 |
|
||
|
how much is it for some top gun spark plugs on a ef fairmont and some new igntion leads as well lookin at NGK or BOSCH
|
||
| Top | |
||
| phongus |
|
|||
|
well i got new bosch spark leads for 35 bux (bought them seperately) from SuperCheapo. had to buy 7 seperate ones cause the pack was selling for like 50 bux or something. i dunno why.
and spark plugs NGKs would cost u about 20 bux a pack of 6? for generic types and then u have the iridium which will be about 100 or something. dont quote me on those prices. asked for them when they just came out. phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 61 guests |
