|
Froudey |
|
||
|
i got a feeling you blokes have hit the nail on the head cause the stero didn't work when the green and yellow wire was hooked up. so i just hooke the constant power and accessories up to the blue and white wire.
so what wire is what is GreenYellow Wire accessorie or constant??? BlueWhite Wire constant or accessorie???
_________________ R.I.P Tobias my son. |
||
Top | |
EL__Fairmont |
|
|||
|
I can't believe how many threads i have read about cars not starting after homer simpson (doh!!) electrical installations.
DISCONNECT BATTERY FIRST!!!!!!!!!!!!!! before any electrical installation, always remove the negative cable first and install last.
_________________ 97 EL Fairmont 4l OHC .Silver. |
|||
Top | |
TURBO_GHIA |
|
|||
|
green yellow is to the battery THERE are 2 of them connect both to the yellow wire on the back of the headunit and replace the CRT fuse
_________________ HMMMM BOOST !!!
|
|||
Top | |
stomper |
|
|||
|
twason wrote: stomper wrote: twason wrote: If it is cranking then I don't think it is smartlock related. As mentioned check all fuses again. Its cranking but not starting and you havnt touched anything to do with the smart lock besides the CRT_LMP then yes it is smartlock related. If the CRT_LMP is blown the smartlock isnt getting power and if it doesnt get power the ECU dont get the message to enable the injectors. Well I could be wrong but my impression was that smartlock disables the starter and the ECU. I checked the smartlock documentation and it agrees with me, here is a quote from it Quote: The immobilised state is indicated by the Smartlock warning jewel (LED) as a rapid flash rate. The system enters the immobilised state if Smartlock receives at least two incorrect codes when the ignition switch is turned to On. When the car is in the immobilised state, you cannot start the engine, as the BEM has disabled both the starter motor, and the EEC-V system. If the cause of the immobilisation is a corruption of the codes during transfer, you should be able to start the car on the second attempt. If you read what you have just said it says 'The system enters the immobilised state if Smartlock recieves at least two incorrect codes when the ignition is on'...The Smartlock hasnt recieved any errors because it isnt being powered. What happens is when you turn the key to ON it checks the 3 codes around the car like you have said. If 2 of these are wrong then it WILL disable the starter motor and the injectors. But when you turn the key on but the BEM doesnt get powered, even if all the codes are fine, it disables the injectors.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
Top | |
xpression |
|
|||
|
stomper wrote: If you read what you have just said it says 'The system enters the immobilised state if Smartlock recieves at least two incorrect codes when the ignition is on'...The Smartlock hasnt recieved any errors because it isnt being powered. What happens is when you turn the key to ON it checks the 3 codes around the car like you have said. If 2 of these are wrong then it WILL disable the starter motor and the injectors. But when you turn the key on but the BEM doesnt get powered, even if all the codes are fine, it disables the injectors. amen. I've seen soooo many cars towed into work for this same thing it isnt funny. |
|||
Top | |
twase |
|
|||
|
Not that I want to argue but if the starter output is from the BEM how does it work without power? I guess the EF EL is different to the earlier ones.
_________________ BF Fairmont Ghia Series II update. |
|||
Top | |
xpression |
|
|||
|
the BEM opens the circuit to the starter when it immobolises the car, so when the bem has no power, it doesnt open the circuit, but it also doesnt tell the pcm to enable the injectors and spark...
you will find things like power windows, maybe the mirrors, and definately the interior lights wont work too |
|||
Top | |
Froudey |
|
||
|
Problem Solved was that CRT_Lamp Fuse what a silly thing..... oh well cheers
_________________ R.I.P Tobias my son. |
||
Top | |
stomper |
|
|||
|
Froudey wrote: Problem Solved was that CRT_Lamp Fuse what a silly thing..... oh well cheers
Nice to hear that all your problems were solved.
_________________ HOLDENS go like rockets. They fall apart in stages!!! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 3 guests |