|
TURBO_GHIA |
|
|||
|
hey all
ive pulled off the standard little tow bar and i have a HD towbar to put one can anyone shed some light on a few things . 1. main bar at the back doesnt match up with holes of the old one . am i surpose to drill new ones ? 2. where do the other 3 parts of it go . and do i need to drill all the holes for it thanks jarrod
_________________ HMMMM BOOST !!!
|
|||
Top | |
cjh |
|
|||
|
Is the bar a Ford one or Hayman-Reece, or a different brand one.????
If it is Ford or Hayman-Reece, most of the holes in the body are there, except for about 4 of them....they are at a seam where the rear floor section meets the floor section over the diff. There will 1 hole with a grommet in it in the middle of the floor section over the diff.....that is where a triangle sort of shape folded plate with a bar welded to it will go. There should be a bar that goes on the inside at the rear where the trim goes, need to remove it to fit, then replace it. I don't have any pics to help you.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
Top | |
TURBO_GHIA |
|
|||
|
i dont think it has any markings on it .
here are a few pics 1st pic is the triangle bit which i know where it goes. 2nd pic i know where it goes . 3rd pic it doesnt line up to the original holes .should i drill new ones . 4th pic i think it bolts up the the triangle bit under the car but im stuffed if i can figure it out
_________________ HMMMM BOOST !!!
|
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 60 guests |