|
| Jaysen |
|
|||
|
JMM are the only manufacturer to date that have sensible big cams, otherwise you will just loose all round and still get your a*** kicked by a JMM cammed car. Really think this option out and plan your future modifications. It is essential that you match your cam to your head porting ability and stroke
_________________ Dima, Mitch & Jay's RPD |
|||
| Top | |
|||
| Smackdown |
|
|||
|
uglybob wrote: drazull wrote: By bad idle, you do understand this to be allmost on the verge of constantly stalling dont you? That aint cool. agreed. my mate put a stg 3 crow cam in his EF - ok-ish whilst actually driving, but starting/stopping/idling at lights etc - just stupid - could not idle at all - just something to consider! Yeah thats me... If you were to put the cam in first without a chip, I wouldn't recommend revving it up much cause it runs a bit lean up high. Whenever you start the car, you gotta keep revving itfor the first 5 mins or else it will stall. Forget using AC or turning sharply at the low revs. I had to set my base idle at about 1200 before the chip. But after a bit of driving the idle control sensor would freak out and my revs would keep climbing. I put the chip in after 5 days, (had to get it re-programmed in QLD). Moral of the story is, buy the cam, keep saving, buy the chip, fit both at same time.
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| SVO XR6 |
|
|||
|
basicly the (AC and Pwr Steering relies on) idle up gets screwed with a bigger cam as it needs more fuel and a lil more timing at idle. so stalling is goin to be a issue and also cold starts...not cool
also cruise will be rich and wot will be lean...not cool get the chip n cam at the same time
_________________
|
|||
| Top | |
|||
| Smackdown |
|
|||
|
Both jonno the SVO XR6 and I have used/ are using the stage 3 cam with a chip.
Take our advice, do it all at the same time.
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| Spork |
|
|||
|
What sort of chip did you guys get and how much $$$?
Do chiptorque have standard chips for these cams or do you have to get it dyno tuned?
_________________ Manual EL Gli.
|
|||
| Top | |
|||
| Smackdown |
|
|||
|
I'm using chiptorque.
They do have off the shelf chips for these cams, no dyno tuning required. I new chiptorque chip costs about $600 from memory, try to find a 2nd hand one (only costs $100 to re-flash).
_________________ BA Falcon Futura on EGas. Stock as...
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 101 guests |
