|
| lowie57 |
|
|||
|
hey guys, just swaped out the old engine for a el tickford engine, everything went fine apparantly, installed the j3 chip, and it runs. but the hunting on it is terrible! it will drop to around 600rpm then jump up to 1000rpm constantly.. we cleaned out the isc and even put a different one on but it still hunts, and also sometimes when it drops revs it sounds like its back firing a little bit, kind of like a loud exhaust knock kinda thing.. bit hard to explain. and one have any suggestions as to what i can do?
|
|||
| Top | |
|||
| Johnson stroker |
|
|||
|
what does it do without the J3 in? could be a bad tune?
_________________
|
|||
| Top | |
|||
| lowie57 |
|
|||
|
i havnt tried that yet. would it be ok starting a tickford engine with a gli ecu?
|
|||
| Top | |
|||
| TROYMAN |
|
||
|
also if your ignition timing is to far advanced or retarded it can cause it to hunt..
|
||
| Top | |
||
| lowie57 |
|
|||
|
as far as the timing goes.. i have read some post about it, but im not sure what i meant to be touching/adjusting?
|
|||
| Top | |
|||
| lowie57 |
|
|||
|
just started it without the J3 in and it was the same, if not a little worse, and there was a clicking noise coming from the dash, like relays were turning on and off kinda thing without the chip.
|
|||
| Top | |
|||
| TROYMAN |
|
||
|
its an el???
it has a dizzy, and is adjustable, but if you havnt moved the dizzy it might be ok ,still couldnt hurt to check the timing.. |
||
| Top | |
||
| lowie57 |
|
|||
|
how do i actually get to the dizzy to look?
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 117 guests |
