Fordmods Logo

Lifters. 

 

Page 1 of 1 [ 8 posts ] 

 
 Post subject: Lifters.
Posted: Mon Jul 16, 2007 8:49 pm 
Getting Side Ways
Offline

Age: 38

Posts: 3894

Joined: 15th Nov 2004

Gallery: 24 images

Ride: BF MKII V8 Fairmont Ghia

Location: Perth
WA, Australia

ok, so did my head gasket this week. apart from that taking up way to much time and way to much s**t going wrong i now have some ticking lifters.

i did previously have ticking lifters but only some mornings and at worst they were quiet after about 10 minutes, usually only a few.

Now, i havnt driven my car much since the headgasket cause of other issues. But i just had it idling out the front for about 20 minutes, followed by a 5 minute drive and its still ticking very loud.

After a headgasket how long would you say is normal? i was expecting maybe 10 minutes for them to stop.


pretty p****d off right now cause i cbf pulling it apart again. maybe the car will just vanish over night? :D

 

_________________

2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 9:10 pm 
Getting Side Ways
Offline

Age: 57

Posts: 504

Joined: 2nd Dec 2006

Ride: EF wagoon

Location: perth
WA, Australia

have you checked the oil level.
changed the oil and filter.
was the oil and coolant mixed before you did the gasket?

 

_________________

EF GLi Wagoon
Grandpa Spec

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 9:25 pm 
Getting Side Ways
Offline

Age: 38

Posts: 3894

Joined: 15th Nov 2004

Gallery: 24 images

Ride: BF MKII V8 Fairmont Ghia

Location: Perth
WA, Australia

yeh, changed the oil and filter last night.

dont think coolant and oil mixed. i caught it early.

 

_________________

2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 10:13 pm 
Getting Side Ways
Offline

Age: 57

Posts: 504

Joined: 2nd Dec 2006

Ride: EF wagoon

Location: perth
WA, Australia

not sure. might have a bit of muck in the rocker gear or oil. i would try driving it for a couple of days and maybe changed the oil again. it should get better, but if it doesn't at least the lifters are easy to replace. If you do replace them, i was told there are some retaining clips that cost about 30 bucks a set and some people skimp on them. Apparently if you don't fit them, the next time the rocker gear is removed the hla's can fall out and sometimes fall down into bad places. :x

 

_________________

EF GLi Wagoon
Grandpa Spec

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 10:18 pm 
Getting Side Ways
Offline
User avatar

Age: 38

Posts: 795

Joined: 14th Jun 2005

Gallery: 11 images

Ride: EF f a i r m o n t

Power: 315 rwkw

Location: perth
WA, Australia

did u re shim the cam right.

 

_________________

1995 EF Fairmont with all the Gear.

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 10:23 pm 
Getting Side Ways
Offline

Age: 38

Posts: 3894

Joined: 15th Nov 2004

Gallery: 24 images

Ride: BF MKII V8 Fairmont Ghia

Location: Perth
WA, Australia

yeh, im 99.99% sure i reshimmed it all good.

had 2 in every rocker arm previously and have 2 in every arm now.

ill attach a video file i just made. note it sounds alot worse in real life, and alot more of a metallic sound. i just took it for a 15 minute drive and then took this video.

http://members.ii.net/~fayduda/lifters.3gp

 

_________________

2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 10:46 pm 
Getting Side Ways
Offline
User avatar

Age: 71

Posts: 3555

Joined: 7th Nov 2004

Gallery: 4 images

Power: 482 rwkw

Location: Penrith
NSW, Australia

That sounds BAD !!!!! Did you fit chain tensioner correctly ?? Take rocker cover off and check if oil is getting up there ?? Some gasket may have found its way into an oil gallery etc??? Then check pre load on each lifter..

 

_________________

As in ZOOM 126 edition
331 Dart block,3.25/ 4340 steel crank, Oliver rods,TFS ported track heat heads, TFS track heat inlet Twin SC61 turbo's
Project 1UZ-EF has started.. S475 Turbo 4.0 V8 Mustang Celica.....

Top
 Profile  
 
 
Posted: Mon Jul 16, 2007 10:52 pm 
Getting Side Ways
Offline

Age: 38

Posts: 3894

Joined: 15th Nov 2004

Gallery: 24 images

Ride: BF MKII V8 Fairmont Ghia

Location: Perth
WA, Australia

yeh, the chain has tension. i checked that when i did the tensioner. was no slack in it.

think tomorrow might entail pulling it apart and cleaning all the lifters out.

 

_________________

2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 8 posts ] 

Who is online

Users browsing this forum: No registered users and 51 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Thu Nov 28, 2024 2:47 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names