Fordmods Logo

limp home 

 

Page 2 of 2 [ 23 posts ] Go to page Previous  1, 2

 
Posted: Mon Aug 04, 2008 1:01 am 
Technical Contributor
Offline
User avatar

Age: 60

Posts: 5659

Joined: 14th Jan 2005

Gallery: 10 images

Ride: 96 XH/97 EL

Location: South Coast
NSW, Australia

^^^^Good point - the 'goose' has a separate code, so he probably didn't turn the wheel.
Nigel wrote:
You should probably note that like TPS Sensors, if they have dirt in them they become non-linear : you might read the correct resistance, but a small bump will change them off the scale (and then the ECU goes into limp-home mode).
So we've given no definitive advice on how to know for sure if the trans select pot is at fault.
If we assume reverse lights work okay, and the engine starts in park or neutral - How would you rule the Neutral safety switch out ?????
We also don't want to swap it with another.
What would you do ???

 

_________________

96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl
97 EL Futura S/W: LPG, Alarm, LED int Lts, Trip Comp, F/Lane Dome Lt, Climate Ctrl, T5 Conversion

Top
 Profile  
 
 
Posted: Mon Aug 04, 2008 1:14 am 
Getting Side Ways
Offline

Posts: 2464

Joined: 5th Nov 2004

Gallery: 7 images

Location: Brisbane
QLD, Australia

The only advice I have here is swap for known good (that is, beg, borrow and steal!). See if the problem goes away.

While I think about it - another solution in the past has been to spray some contact cleaner (or wd40) into the contacts in the two gearbox connectors in the engine bay - they sometimes get corrosion/other crap in them and cleaning them/lubricating them can make the problems go away.

Ive had two faulty Selector switches. The problem is that its not on/off - its a fairly small resistance so they do go "intermittent" rather than reliably failed :(

Problem is almost always made worse by playing manuals (shifting the auto manually)
Top
 Profile  
 
 
Posted: Mon Aug 04, 2008 11:29 am 
Getting Side Ways
Offline

Age: 115

Posts: 927

Joined: 27th Sep 2007

Location: Adelaide
SA, Australia

luthor wrote:
green car wrote:
Engine on ignition on
411 - base idle speed irregularity
521 - power steering pressure switch(open circuit)

Did you "goose the throttle" and turn the steering wheel during this test?

No i couldnt hold the test light floor the throttle and turn the wheel at the same time.
So the wheel never got turned half a turn,how much difference will that make in the accuracy of the codes?
Could this have made the short circuit of the ps switch code appear?

 

_________________

165 Killer Wasps all packaged in a green kmart car, almost an explorer in a way...

Top
 Profile  
 
 
Posted: Mon Aug 04, 2008 7:20 pm 
Parts Gopher
Offline

Posts: 72

Joined: 13th Mar 2007

Location: Melbourne
VIC, Australia

green car wrote:
luthor wrote:
green car wrote:
Engine on ignition on
411 - base idle speed irregularity
521 - power steering pressure switch(open circuit)

Did you "goose the throttle" and turn the steering wheel during this test?

No i couldnt hold the test light floor the throttle and turn the wheel at the same time.
So the wheel never got turned half a turn,how much difference will that make in the accuracy of the codes?
Could this have made the short circuit of the ps switch code appear?


Yes, that's why I asked, both of those codes may disappear if you do the test properly.
Top
 Profile  
 
 
Posted: Tue Aug 05, 2008 5:15 pm 
Getting Side Ways
Offline

Age: 115

Posts: 927

Joined: 27th Sep 2007

Location: Adelaide
SA, Australia

When i checked the base idle speed as it says in the book it was at almost 900 rpm,which was out of the 600-800 range of ok so i adjusted it to 720rpm as the book says.
So the base idle code appeared because the idle was too high.
A new pressure switch is only 15 bucks so ill just replace that.
I will be rechecking the codes with the full procedure and ill go from there.

 

_________________

165 Killer Wasps all packaged in a green kmart car, almost an explorer in a way...

Top
 Profile  
 
 
Posted: Tue Aug 05, 2008 6:42 pm 
Technical Contributor
Offline
User avatar

Age: 60

Posts: 5659

Joined: 14th Jan 2005

Gallery: 10 images

Ride: 96 XH/97 EL

Location: South Coast
NSW, Australia

green car wrote:
A new pressure switch is only 15 bucks so ill just replace that.

snap0964 wrote:
If you turn your steering wheel with the engine idling, and the revs increase, then the PS s/w is okay.
Replacing components willy nilly will waste money - your call though.

 

_________________

96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl
97 EL Futura S/W: LPG, Alarm, LED int Lts, Trip Comp, F/Lane Dome Lt, Climate Ctrl, T5 Conversion

Top
 Profile  
 
 
Posted: Wed Aug 20, 2008 6:15 pm 
Getting Side Ways
Offline

Age: 115

Posts: 927

Joined: 27th Sep 2007

Location: Adelaide
SA, Australia

After owning the ef for 8 months and having it go into limp home mode countless times, its finally fixed.
It ended up being the s1 solenoid, so i got the trans flushed as well and all seems to be going well.
Thanks for all ideas and help, cheers.

 

_________________

165 Killer Wasps all packaged in a green kmart car, almost an explorer in a way...

Top
 Profile  
 
 
Posted: Thu Jan 15, 2009 7:33 pm 
Parts Gopher
Offline

Age: 35

Posts: 52

Joined: 7th Nov 2006

Ride: NF fairlane

Location: melbourne
VIC, Australia

whats the s1 solenoid do and where is it?? my nf fairlane does a strang thing at a 100 on the freeway the D on the dash will turn on and off and the revs will go from 1800 to 2200 for about 5 seconds any help would be great.

 

_________________

Is There Life After Death Touch My Car And Find Out!!!

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 23 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: Google [Bot] and 60 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Fri Nov 29, 2024 12:38 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names