|
| BlkEB2 |
|
||
|
I've been through the sticky's with no luck and asked this about two weeks ago.....Anyone seen the 4.0 make a Gudgeon pin knock/rattle at 200,000 klms.....I don't even thrash it! Have recently replaced front main seal and cover gasket.....The refitted the cam chain tensioner a few times but still no good.....Even checked pistons with plugs out but could'nt see any t.d.c delay when turning over by hand.....Is either No.1 or 2 cyl???
I reckon it is Gudgeon but just want other experienced opinions.... |
||
| Top | |
||
| Pulco |
|
||
|
the pins are press fitted so for it to rattle it would have to be broken or somethin else be broken, i dont think that they could wear that much to make the piston or rod loose...
_________________
|
||
| Top | |
||
| BlkEB2 |
|
||
|
Yes that's tru but im was thinking it still may be worn......Looks like i'm goin to have to pull the front cover of again and check the tensioners
|
||
| Top | |
||
| Krytox |
|
|||
|
sure you've released the spring?
cant really go from gudgeon pin to chain tensioner, they're far from together! undo a lead when its running you'll find out soon enought if its a pin/bearing.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| mreb |
|
|||
|
i replaced all the bearings ,oil pump timing chain and tensioner but stil got that noise was told its the crank or piston slap .
|
|||
| Top | |
|||
| The Dog |
|
|||
|
My bet is piston slap or a bottom end knock. Before we rebuilt the EB I would've sworn the knock was either gudgeon or piston slap...turns out it was bearing knock. Made me look pretty foolish
 
_________________ You'll ride a black tornado across the western sky
|
|||
| Top | |
|||
| mreb |
|
|||
|
it wont hurt it ive been driving mine like that for 2 years now still runs good just sounds like a diesel when i start it and rev it .
|
|||
| Top | |
|||
| BlkEB2 |
|
||
|
Damn! I'm just curious as to why it seems to have happened just after changed front main seal and cover gasket.....And 'most' of the 4.0 do alot more kays than 200,000......Not what i need right now
 Was thinking i might rip head and sump off if it's only a little end and if the bore measures o.k still up i could replace just that rod and possibly even re-use the piston.....Then again for all that may as well just throw a low kay short motor in and use my worked head on that.....???
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 60 guests |
