|
| paj001 |
|
||
|
Just installed au1671 profile into my el ghia(Hybrid) but not very pleased with the gain it has given me.
Does anyone have any experience with this setup? Throttle response seems less. Maybe I will advance timing a touch Or maybe get the injecters cleaned. |
||
| Top | |
||
| fordfreak ef |
|
|||
|
paj001 wrote: Just installed au1671 profile into my el ghia(Hybrid) but not very pleased with the gain it has given me. how many km old is your engine??
Does anyone have any experience with this setup? Throttle response seems less. Maybe I will advance timing a touch Or maybe get the injecters cleaned. NA?? im guessing so.... previous engine mods?? previous cam?? |
|||
| Top | |
|||
| paj001 |
|
||
|
3'' mandrel intake,xr8 intake,hurricanes,2.5 exhaust
Original cam was tickford. 5 speed conversion. 206000kms on the clock. |
||
| Top | |
||
| GeZza200 |
|
||
|
mmm bit wierd, im about to put that cam in mine. Its the one up from the one i have at the moment and the one i got at the moment goes great. Do you have vernier gear?
_________________ EL Futura: CVE head, Wolf V500, ICE Ignition and Coil, 36lb injectors, Walbro 255lb, Paci comps, 3" exhaust, T5, Harrop Truetrac with 3.9s. Now with 198.9rwkw, (~185rwkw and 13.80 @99.1mph) with more power to come |
||
| Top | |
||
| mitchg911 |
|
|||
|
did you maintain the correct cam timing??
find true tdc ( pull #1 sparkplug and put a screw driver in there, wind the motor upto near tdc and you'll be able to feel with the screw driver when the piston gets to the top of its movement) once you know where tdc is, check the cam and ignition timing.. cam mark should be 3mm above the head on the inlet side of the motor IIRC.. -mitch
_________________ BF XR6T 6spd Auto. 60lb injectors, Hybrid Cooler, Custom Piping, Custom Surge Tank, Actuator. |
|||
| Top | |
|||
| paj001 |
|
||
|
Gezza 200-It does not have a vernier gear but am interested in getting one.
mitchg91-Going to check this right now,but pretty sure its ok. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 60 guests |
