Fordmods Logo

MY ED Overheated!! 

 

Page 1 of 2 [ 26 posts ] Go to page 1, 2  Next

 
 Post subject: MY ED Overheated!!
Posted: Sat Oct 08, 2005 7:15 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 5924

Joined: 5th Nov 2004

Gallery: 7 images

Ride: Ford FPV FG F6 310

Power: 149 rwkw

Location: Brisbane
QLD, Australia

Going up to the coast yesterday my s**t ed's temp gauge slowly creeped up to the hot side.
I noticed it before the light came on.
I then turned the A/C off, and let it sit at idle where it then came down.

I basically couldn't go over 90 km/h on the highway or it would creep up to the red again.
Why would it do that?
I just flushed the cooling system out yesterday and got a new thermostat from ford.

 

_________________

NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter!

R.I.P. BF XR6 Turbo - You will not be forgotten :( 12.06@120MPH

Top
 Profile  
 
 
Posted: Sat Oct 08, 2005 7:20 pm 
Technical Contributor
Offline
User avatar

Age: 45

Posts: 4093

Joined: 20th Mar 2005

Gallery: 2 images

Ride: 2.0 Turbo VW

Power: 142 rwkw

Location: Seaford State:
VIC, Australia

incorrect thermostat temp?
impellor on pump worn?

all a bit scarey if there was no problem yesterday i'd be 99% sure it'd be the thermostat if thats all you replaced besides fluid!

hope this helps
Andrew

 

_________________

Carefree, we may not be number one, but we're up there.

Top
 Profile  
 
 
Posted: Sat Oct 08, 2005 7:25 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 5924

Joined: 5th Nov 2004

Gallery: 7 images

Ride: Ford FPV FG F6 310

Power: 149 rwkw

Location: Brisbane
QLD, Australia

well the car got a bit warm last week,so i thought i'd drain the coolant, flush it out, refill it, and replace thermostat.
do teh clutch fans have a tendency to slip over time, or do they lock up when they fail?

 

_________________

NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter!

R.I.P. BF XR6 Turbo - You will not be forgotten :( 12.06@120MPH

Top
 Profile  
 
 
Posted: Sat Oct 08, 2005 8:28 pm 
Tyre Shredder
Offline

Age: 50

Posts: 314

Joined: 22nd Aug 2005

Gallery: 1 images

Location: Kernot.Vic.
VIC, Australia

same thing happened to my ED,i flushed the radiator and changed everything.Ended up being the radiator,new radiator have not had a prob since.
Top
 Profile  
 
 
Posted: Sat Oct 08, 2005 8:41 pm 
Getting Side Ways
Offline

Posts: 988

Joined: 4th Dec 2004

Ride: el faimont, dual fuel

Location: melbourne
VIC, Australia

did you get a different coolant from last time?

 

_________________

why do u write in here.

Top
 Profile  
 
 
Posted: Sat Oct 08, 2005 8:52 pm 
Tyre Shredder
Offline

Age: 50

Posts: 314

Joined: 22nd Aug 2005

Gallery: 1 images

Location: Kernot.Vic.
VIC, Australia

no i dont think so,just new radiator cause the old one had to many fins missing at the front and wasnt flowing enough water threw it.It looked fine but when i got it out you could tell it was buggered.
Top
 Profile  
 
 
Posted: Sat Oct 08, 2005 9:07 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 5924

Joined: 5th Nov 2004

Gallery: 7 images

Ride: Ford FPV FG F6 310

Power: 149 rwkw

Location: Brisbane
QLD, Australia

msman - i used different coolant, but i had already flushed the old stuff out, so no contamination if that's what you're saying.

 

_________________

NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter!

R.I.P. BF XR6 Turbo - You will not be forgotten :( 12.06@120MPH

Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 1:14 am 
Getting Side Ways
Offline
User avatar

Age: 71

Posts: 3555

Joined: 7th Nov 2004

Gallery: 4 images

Power: 482 rwkw

Location: Penrith
NSW, Australia

Air lock ??

 

_________________

As in ZOOM 126 edition
331 Dart block,3.25/ 4340 steel crank, Oliver rods,TFS ported track heat heads, TFS track heat inlet Twin SC61 turbo's
Project 1UZ-EF has started.. S475 Turbo 4.0 V8 Mustang Celica.....

Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 3:46 pm 
Getting Side Ways
Offline

Posts: 988

Joined: 4th Dec 2004

Ride: el faimont, dual fuel

Location: melbourne
VIC, Australia

the ford thermostats have a hole at the top so this should not have happened.

 

_________________

why do u write in here.

Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 6:59 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 5924

Joined: 5th Nov 2004

Gallery: 7 images

Ride: Ford FPV FG F6 310

Power: 149 rwkw

Location: Brisbane
QLD, Australia

i'm leaning towards a clogged radiator, and it looks pretty original.
the coolant wasn't the best when i bought it either.

 

_________________

NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter!

R.I.P. BF XR6 Turbo - You will not be forgotten :( 12.06@120MPH

Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 7:49 pm 
Tyre Shredder
Offline

Age: 50

Posts: 314

Joined: 22nd Aug 2005

Gallery: 1 images

Location: Kernot.Vic.
VIC, Australia

if its tha original radiator then it is prob buggerd by now.How many k's has it done?
Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 7:51 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 5924

Joined: 5th Nov 2004

Gallery: 7 images

Ride: Ford FPV FG F6 310

Power: 149 rwkw

Location: Brisbane
QLD, Australia

207,000km.
I can get a new one for around $170, or get this one flushed and pressure tested.

 

_________________

NEW RIDE - FPV FG F6 6spd Auto. 12.26@114MPH, 1.88 60FT on Cheapy Tyres with 38PSI - Stock except K&N filter!

R.I.P. BF XR6 Turbo - You will not be forgotten :( 12.06@120MPH

Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 8:18 pm 
Getting Side Ways
Offline

Posts: 4967

Joined: 22nd Nov 2004

Location: FAR FAR AWAY LAND
QLD, Australia

Get a new one

 

_________________

Image

Top
 Profile  
 
 
Posted: Sun Oct 09, 2005 8:43 pm 
Tyre Shredder
Offline

Age: 50

Posts: 314

Joined: 22nd Aug 2005

Gallery: 1 images

Location: Kernot.Vic.
VIC, Australia

nah get a new one then you dont have to touch it again.
Top
 Profile  
 
 
 Post subject: HOT
Posted: Mon Oct 10, 2005 8:52 am 
Oompa Loompa
Offline
User avatar

Age: 53

Posts: 42

Joined: 13th Dec 2004

Location: Perth
WA, Australia

Yeah, I agree, get a newby. Whereabouts in Brisvegas are you? Cause a bloke out in Ipswich does the bigger (3core?) radiators for about the same price fitted and guaranteed.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 2  [ 26 posts ]  Go to page 1, 2  Next

Who is online

Users browsing this forum: Google Adsense [Bot] and 104 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Sun Nov 24, 2024 5:54 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names