Fordmods Logo

My new Exhaust 

 

Page 2 of 2 [ 21 posts ] Go to page Previous  1, 2

 
Posted: Sun Dec 12, 2004 6:43 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 1680

Joined: 5th Nov 2004

Gallery: 1 images

Ride: 220kw 1600 Datto

Location: Scaaabz
WA, Australia

SQUEAK wrote:
Sounds good SVO.....

Any chance of posting up a sound file???



i got nfi how too :?

 

_________________

Image

Top
 Profile  
 
 
Posted: Sun Dec 12, 2004 6:44 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 1680

Joined: 5th Nov 2004

Gallery: 1 images

Ride: 220kw 1600 Datto

Location: Scaaabz
WA, Australia

SQUEAK wrote:
dropping your exhaust is not a defect!!!

As long as the exhaust outlet is a certain amount away from the last opening window its ok....and at the diff is fine. Ive been pulled over heaps of times with the exhaust and a few of my mates have there exhausts dropped at the diff and cops havent said anything......


Serious!!!
cool, i was a little worried about that

 

_________________

Image

Top
 Profile  
 
 
Posted: Sun Dec 12, 2004 7:06 pm 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 1680

Joined: 5th Nov 2004

Gallery: 1 images

Ride: 220kw 1600 Datto

Location: Scaaabz
WA, Australia

Modified exhaust systems

Modified exhaust systems may be fitted to passenger vehicles provided the following conditions are met :

1. The system is efficient.

2. The exhaust system does not pass closer than 25mm to fuel tanks or the body floor.

3. The system does not foul the body work or limit axle travel.

4. No part of the system projects below the rim lower edge

5. The system terminates behind the last body panel.

6. Systems on the left hand side of the vehicle do not deflect gases directly to the left.

7. The noise level of the modified system must not exceed the noise level of the manufacturer’s original system by a noticeable amount.

8. Side exhaust systems (sometimes called lake pipes) are not permitted.

9. The system must be effectively supported and must be free from cracks and leaks.

10. Where the vehicle is subject to ADR 27A - Emission Control. Extractors may be fitted, but the features of the original manifold must be maintained (i.e.. hot air transfer tube, manifold to air connection). Vehicles subject to unleaded fuel control emissions (ADR 37) must remain as specified by vehicle manufacturer..

11. Noise level will be the most important factor in assessing any exhaust system. Close attention will be given to this factor during examinations and in the on-road situation.


I think ill be ok 8-)

 

_________________

Image

Top
 Profile  
 
 
Posted: Sun Dec 12, 2004 9:38 pm 
Getting Side Ways
Offline
User avatar

Posts: 1960

Joined: 6th Nov 2004

Gallery: 22 images

Power: 315 rwkw

Location: Under the flight path of incoming packpackers
NSW, Australia

5. The system terminates behind the last body panel

Is the bootlid considered a body panel?

You might want to atleast have a dummy pipe so they dont get suss when they hear you and then look and notice the missing tail pipe...
Top
 Profile  
 
 
Posted: Sun Dec 12, 2004 10:10 pm 
Smokin em up
Offline
User avatar

Age: 69

Posts: 285

Joined: 14th Nov 2004

Gallery: 10 images

Ride: buick

Location: melbourne
VIC, Australia

CHEF wrote:
5. The system terminates behind the last body panel

Is the bootlid considered a body panel?

You might want to atleast have a dummy pipe so they dont get suss when they hear you and then look and notice the missing tail pipe...


I sure that ute's are OK with dumper pipes but sedans & wagons I think have to exit from the side rear or rear. Also I don't think it would pass a R/W in Vic. I would think fumes from under the car might be the defect notice in Vic :?: Driving the thing as a daily hacker the noise would piss you off. The charger I had had the thrush side pipes that are illegal now I was for ever burning my lower legs on the pipes when I stepped out of the car .

ghiaman
Top
 Profile  
 
 
Posted: Mon Dec 13, 2004 12:04 am 
Getting Side Ways
Offline
User avatar

Age: 40

Posts: 1680

Joined: 5th Nov 2004

Gallery: 1 images

Ride: 220kw 1600 Datto

Location: Scaaabz
WA, Australia

CHEF wrote:
5. The system terminates behind the last body panel

Is the bootlid considered a body panel?

You might want to atleast have a dummy pipe so they dont get suss when they hear you and then look and notice the missing tail pipe...


Im going to get the "U" shaped bit in the tickford kit filled with a removable bit, incase i put the tailpiece back on.

 

_________________

Image

Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 21 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: Google [Bot] and 66 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Fri Nov 22, 2024 6:30 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names