|
| archibald the simple |
|
||
|
ive got the ebxr6 and have put new front breaks on my car and that was piss easy now i started on the back i cant get the f**k things back in so i can put the new pads in do i just need to band it back in or is there somthing else i need to do.... i got the s**t and took the whole break off to try to find a way but its got me stumped....
_________________ lesbian nazi hookers abducted by aliens and forced in to weight loss programs..... the turtle is natures suction cap..... |
||
| Top | |
||
| kermey |
|
|||
|
there is a screw u can un do and it will release the pressure or if you dont want brake fluid every where use something to push the piston back, but be sure to take the cap off the brake fluid tub under your bonnet!! hope this helps!!!
|
|||
| Top | |
|||
| fuzion |
|
||
|
use a gclamp, $2 from cheapo supercheap! and open up your fluid cap
|
||
| Top | |
||
| archibald the simple |
|
||
|
that was fine in the front but the g clamp wont work it seems to screw back in its too hard to screw it back in by hand so i thought there might be some trick to it. its pissin me off
_________________ lesbian nazi hookers abducted by aliens and forced in to weight loss programs..... the turtle is natures suction cap..... |
||
| Top | |
||
| madmax |
|
|||
|
From memory on the EB, where the handbrake lever is on the back of the caliper. You need to remove this lever, then turn the part that it was bolted too as you press in the piston. I hope this explains it well enough for you.
_________________
|
|||
| Top | |
|||
| TURBO_GHIA |
|
|||
|
there's a special tool you need it goes onto a racket and screws back in
_________________ HMMMM BOOST !!!
|
|||
| Top | |
|||
| madmax |
|
|||
|
EDMONTY wrote: there's a special tool you need it goes onto a racket and screws back in
There maybe, however i've never needed it. I just winded it back in as I pushed the piston in.
_________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 38 guests |
