hey i have just taking the plenom and exhaust manifold of my engine.
the engine is currently sitting in a trailer and i want to pressure clean it before i put it back in my car.

has anyone made anything up that will bolt over the inlet and outlet holes to make cleaning it easyer and so i dont have to worry about spraying water in my engine.

cheers. liam

why didn't you keep the manifolds on and then just clean it that way? Also make sure you cover the dizzy/coil pack and any other electrical bits prior to cutting sick at it with the water.

phong =P~

id just shove plastic bags in each port!!!

cause there was s**t every where and plus a cat got throwen up in my engine bay and got chewer up. so i have road grim fur and bits of cat every where lol ,so i wanted to make sure i got all of it. i was thinking of getting my brother to take the gaskets into his work and getting some like 2mm stainless steal plates made up. that way i can bolt them on with the gasket as well. im pretty sure that would seal up sweet as.
what do you rekon

should do the trick I guess...squash some plastic or rubber around it too...just for safety.

Dim sims in the engine bay aye? New meaning to fresh.

phong =P~