How much of a BA falcon do I need to get Ford to module match?

I am installing a BA motor into a MAV and rather than wait until its in and wired I was wondering if I present with the complete wiring loom, PDB and fuse box with all the PCM, ICC,BEM and TILA plugged it, plus some keys and a battery would they be able to module match them as they are from different cars?
Does the HIM need to be matched as well? I am planning on using that to control the Patrol's heater box.

Sounds like too much work.......LOL.

Good luck with it though.....would be interesting to see how well it performs over the old TB42.

much much easier to throw all that away, install an earlier throttle body and run an aftermarket ecu...

I appreciate the performance advantages of after market but for its intended use I need reliability and serviceability, I don't want to be stuck out the middle of no where in 10 years time wondering how I am going to get home, its going in a 4wd BTW.

Anyway, a visit to ford has left me feeling very positive on this.

Have a read of this
http://www.outerlimits4x4.com/viewtopic ... tb45+turbo

Yes that's my reference for the mechanical bits.