|
| Gaz |
|
||
|
Just wonder what the quickest way to do this is?
gregories says to remove the TB, fuel connections, and pressure regulator, all that required or is there a quicker way? just wanting to replace the injectors with some reco ones, it it possible to squeeze them out without taking everything off?
_________________ 2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows |
||
| Top | |
||
| Slick |
|
|||
|
disconnect the fuel pump first, run the engine to relief the fuel pressure.
go by the book, it never fails. you can't squeeze it out, they're like 1 inch into the intake plenum.
_________________ Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!! Pakrat wrote: You can buy them seppertly
|
|||
| Top | |
|||
| Gaz |
|
||
|
hmm, wonder if i have time to do it before it gets dark ... how long should it take?
the book says to replace the o ring on the fuel regulator, if i dont have a new one should i leave it? or is it ok to reuse?
_________________ 2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows |
||
| Top | |
||
| snap0964 |
|
|||
|
IIRC I removed the airducting around the top of the injector rail, and unbolted the injector rail - all 10mm bolts, the rearmost was in a tight spot.
Removed the clips and electrical connectors, and removed the injectors from the rail in situ. For what they cost, I'd fit a new o ring.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| stockstandard |
|
|||
|
Remove the throttle body
Remove electrical connections from injectors Undo the bolts holding the fuel rail to the manifold pull the fuel rail back so the injectors pop out the manifold Remove the injector c-clips and pull them out the rail (fuel in the rail will run out) Do it when the engine is cold so fuel wont spill on anything hot and there will be no pressure in the rail.
_________________ Stoke me a clipper, I'll be back for Christmas |
|||
| Top | |
|||
| Gaz |
|
||
|
cheers guys.
all done, why does everything i do with cars though end up being finished int he dark, gettin eaten by mozies and using a desk lamp to see? worse bit was the TB, only had a pissy allen key. took fuken ages like 1/4 turn at a time.
_________________ 2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows |
||
| Top | |
||
| griffo161 |
|
||
|
Mate you dont need 2 take the TB off. If ur just doind the injectors then all you have to do is undo the 4 10mm bolts holding the fuel rail in place, then disconnect the injectors them selves, then there should be little clips which hold the injector onto the fuel rai, take them off and after u have pulled the fuel rail back away from the inlet manifold (you can do this anytime after u undo the 4 10mm) then the injectors will just pull out.
Make sure when you are putting the new ones in that u use a little bit of Vasso on both sides of the injectors. Griffo
_________________ ED XR6 manual for sale. MOMO steering wheel and alot of extra's. PM for more info.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 82 guests |
