|
| krisisdog |
|
|||
|
I think it cost me $60 off for a Kincrome 14mm impact socket and 75odd cm bar. Not what I'd call expensive by any means.
|
|||
| Top | |
|||
| fairlane6970 |
|
|||
|
WD40 is a penetrating oil with a much lower viscosity than engine oil, that is all - even though I did not mention it, that is just a thought.
_________________
|
|||
| Top | |
|||
| Jonathan Kakousidis |
|
|||
|
when i had a stuben head bolt ive just used
a 14mm 1/2 inch impact socket 600mm breaker bar and if the still dont come loose i get a mate to lightly tap the back of the socket while i turn it comes off every time haven sheared/rounded a bolt yet
_________________ MY BABIES |
|||
| Top | |
|||
| ILLaViTaR |
|
||
|
You're not gonig to get anywhere with those tools.
If you have to go cheap, get 1/2 drive, you're current tools are way to weak. |
||
| Top | |
||
| viper1431 |
|
||
|
is it possible to remove the head with the inlet manifold still attatched?
Removing the manifold is the part that's putting me off taking my cyl head off =/ |
||
| Top | |
||
| Gab1 |
|
|||
|
viper1431 wrote: is it possible to remove the head with the inlet manifold still attatched? Removing the manifold is the part that's putting me off taking my cyl head off =/ You can, but it's gonna be a hell of alot easier to remove the manifold first. Gab |
|||
| Top | |
|||
| tickford_6 |
|
||
Posts: 6449 Joined: 11th Nov 2004 |
viper1431 wrote: is it possible to remove the head with the inlet manifold still attatched? Removing the manifold is the part that's putting me off taking my cyl head off =/ You don't need to remove the intake manifold. You just unbolt it from the head, there are two support brackets that will hold it in place. |
||
| Top | |
||
| viper1431 |
|
||
|
The unbolting bit is the part that makes me want to roll the car into a lake.. i have the worst time trying to get those darn intake bolts off for some reason =/
|
||
| Top | |
||
| efxr6wagon |
|
||
|
It's a right royal pain. But I found that with a good 10mm spanner and a 10mm 1/4-drive socket with swivel and extension - and a lot of patience - it can be done successfully. Clearly, Ford did not intend the manifold to be removed with the engine in the car - but then, they only have to put it together
_________________ 95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google [Bot] and 101 guests |
