|
| Sniffer |
|
||
|
Have a 04 ba 6 cyl ute and when its warm -hot it idles rough ,not to the point of stalling ,but u can feel the shudder.Now ford have it 3 times and keep resetting the computer.No codes r showing.Now im using 10w/40 oil in it,and they reckon its too thick and could be causing the rough idle.They use 10w/30 oil.They did say the tps causes it sometimes and wont show up as a code.Its a manual,tehy reckon the throttle body etc are all ok.Any ideas.
|
||
| Top | |
||
| shannonwulff |
|
|||
|
usually you get a rough idle from your injectors, leads or sparkies being a bit old and worn out, but your car is pretty new so i doubt it would be any of those, worth a check though.
_________________ When you do things right, people won't be sure you've done anything at all. |
|||
| Top | |
|||
| Sniffer |
|
||
|
yeh cheers shannon,but i dont have leads ,got platinum plugs,yeh maybe an injector is stufed
|
||
| Top | |
||
| Darkr |
|
|||
|
Sniffer wrote: Have a 04 ba 6 cyl ute and when its warm -hot it idles rough ,not to the point of stalling ,but u can feel the shudder.Now ford have it 3 times and keep resetting the computer.No codes r showing.Now im using 10w/40 oil in it,and they reckon its too thick and could be causing the rough idle.They use 10w/30 oil.They did say the tps causes it sometimes and wont show up as a code.Its a manual,tehy reckon the throttle body etc are all ok.Any ideas.
It says on the cap.... 10w/30..... |
|||
| Top | |
|||
| Sniffer |
|
||
|
changed oil today ,put 10w/30 in it,no difference still idles rough.
|
||
| Top | |
||
| cjh |
|
|||
|
Using 10W40 oil wouldn't hurt it anyway. If you were towing something close to maximum allowable, I'd use Penrite 10W60.
Anyway, check for vacuum leaks, tighten inlet manifold bolts. I have seen when the manifolds weren't machined properly, ( top & bottom halves for the BBM), and this gives sh!tty idle. Does your BA have the little rubbers on top of the coils?
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Sniffer |
|
||
|
thanks for the reply cj.I dont know about the rubber bits mate.Going to try another dealer.
|
||
| Top | |
||
| Molloy |
|
|||
|
oil wouldnt cause a rough idle??
_________________ SS Inductions CAI, K&N Filters, M-spec FMC, Turbosmart BOV, 8psi capa tune, X-force cat. |
|||
| Top | |
|||
| cjh |
|
|||
|
Sniffer wrote: thanks for the reply cj.I dont know about the rubber bits mate.Going to try another dealer.
The rubbers were to stop the coils bouncing off the s/plugs. Apparently they had troubles with this on dirt or rough roads.
_________________ http://youtu.be/jJTh9F3Vgg0 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 34 guests |
