|
| MadMatt |
|
|||
|
I have a R6 cam here (yet to buy verneer) and are after info on whar angle to set it to.
Car is an EF auto. If I cant get the info I need, I will just refit the R1 cam that I also have.
_________________ Member Number 8804 |
|||
| Top | |
|||
| Steady ED |
|
|||
|
if you've got no vernier just install it as is, skipping teeth on the cam gear to change cam timing is a messy way of doing it!
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| MadMatt |
|
|||
|
Steady ED wrote: if you've got no vernier just install it as is, skipping teeth on the cam gear to change cam timing is a messy way of doing it! I will be getting the vernier pior to fitting the R6.
_________________ Member Number 8804 |
|||
| Top | |
|||
| Steady ED |
|
|||
|
ahh okay, misunderstood your post, sorry.
i'd install it at zero and fire one of the Jays RPD boys a PM, try and find out what intake lift @ TDC they had it specced too. not hard to do cam timing at a later date.
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| MadMatt |
|
|||
|
I sent Jaysen a PM on Dec 30 and it is still sitting in the outbox, so looking for info here....
_________________ Member Number 8804 |
|||
| Top | |
|||
| Johnson stroker |
|
|||
|
I'll contact Jaysen and find out the settings for you. Should have an answer by the end of the weekend for you. I have a feeling it was something like 3 degree before TDC, but I could be wrong.
Jaysen pretty much is living in the garage and not using the net these days. Dave
_________________
|
|||
| Top | |
|||
| Johnson stroker |
|
|||
|
OK, TDC should be when intake is open 40 thou, your probably looking for about 3 degrees adv. but measure it properly.
Dave
_________________
|
|||
| Top | |
|||
| MadMatt |
|
|||
|
dc_todd wrote: OK, TDC should be when intake is open 40 thou, your probably looking for about 3 degrees adv. but measure it properly. Dave Thankyou for the info.
_________________ Member Number 8804 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 90 guests |
