|
kyleat1 |
|
||
|
dose any body know were i can find the doc were i can set the isc & gearbox at the same time its something like were you have the reds on then off and put the gearbox in park then drive if any one can tell me as for the life of me i cant find it any were as i have seen it before
|
||
Top | |
SpeedyED |
|
|||
|
What Car are you trying to attempt this on?
_________________ Pre AU Adapters for sale |
|||
Top | |
kyleat1 |
|
||
|
sorry my ef
|
||
Top | |
kyleat1 |
|
||
|
any body
|
||
Top | |
Paxton |
|
||
|
Instructions from the EF & EL Workshop Manual:
Any time the battery is disconnected, the transmission must re-learn the closed and wide-open throttle positions to enable the PCM to determine the proper gear to select for the appropriate throttle position. If the calibration is not performed following power source interruption, the transmission will shift hard and perform poorly from then on. So to calibrate as follows: First of all drive the car to normal engine temp and the thermostat has opened etc Then to verify the correct idlespeed of the engine the following 4 steps should be taken with the vehicle being idled while stationary for approx 1-2 minute in each of the following conditions. NOTE- DO NOT TOUCH THE ACCELERATOR DURING ANY PERIOD OF THE 5 FOLLOWING ADAPTIVE PROCESSES. 1. Neutral with all electrical loads OFF. 2. Neutral with Air conditioning ON. 3. *Drive with all electrical loads OFF. 4. *Drive with Air conditioning ON. After all this has been done then proceed to go on and to do these steps which actually set the TPS values; 5. *To set the closed throttle referance position , place the transmission in Drive, Air con off, and let the engine idle for a minimum of 1 minute. 6. Next, set the wide-open throttle reference position by turning the engine off- but leave the ignition switch to the "ON," position, ie;Idiot lights on etc, then press the accelerator pedal to the floor and hold it their for 1 minute, minimum. 7. Then Place the gear selector to Park and switch off the ignition. 8. Drive the vehicle and check for proper shifting patterns. *As a clarifying note, I guess that for steps 3, 4 & 5 you can place the car in D with the handbrake firmly applied.
_________________ Gunmetal EF XR6 Auto
|
||
Top | |
kyleat1 |
|
||
|
thank you thats what i need
|
||
Top | |
Who is online |
---|
Users browsing this forum: Google [Bot] and 62 guests |