|
gasdea |
|
|||
|
hey guys,
my EL is having smartlock drama's. the thing wont turn over at all, i have done the thirty minute thing, (leave ignition on for 30 mins, turn off then start) after the 30 minutes is up, the smartlock light stays on red. i can then turn the ignition off, back on and start it, thing is, as soon as i turn it off, it wont start again. any help would be appreciated.
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
twase |
|
|||
|
60 minutes on an EL not 30....30 just gets it started not trained.
_________________ BF Fairmont Ghia Series II update. |
|||
Top | |
MAD |
|
|||
|
When you say "wont turn over" do you mean wont crank, or wont start?
If you mean it wont crank, then it's not a smartlock problem. It will probably be your starter motor. With smartlock activated the engine will crank, but fuel (and spark I think) are cut. |
|||
Top | |
gasdea |
|
|||
|
twase wrote: 60 minutes on an EL not 30....30 just gets it started not trained. thanks twase, i'm waiting it out now. so what will the smartlock light do when the hours up? MAD wrote: When you say "wont turn over" do you mean wont crank, or wont start? If you mean it wont crank, then it's not a smartlock problem. It will probably be your starter motor. With smartlock activated the engine will crank, but fuel (and spark I think) are cut. MAD, the engine will not turn over, like rotate. i dont think its the starter as it has a high qaulity aftermarket starter motor recently installed. plus the smart lock light is going off its head.
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
TimmyA |
|
|||
|
The ED's had a problem with a relay in the smartlock module getting dirty contacts and then wouldn't crank...
You tried holding the key to start and bumping the dash just above your left knee under the cluster? Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
Top | |
gasdea |
|
|||
|
timmytimtim wrote: The ED's had a problem with a relay in the smartlock module getting dirty contacts and then wouldn't crank... You tried holding the key to start and bumping the dash just above your left knee under the cluster? Cheers, Tim nah havent tried it mate, i will if twase's advice doesnt work.
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
TimmyA |
|
|||
|
let us know...
Cheers...
_________________ 93 Red ED 5spd Manual Build Thread |
|||
Top | |
gasdea |
|
|||
|
ok i left the ignition on for an hour, turned it off, started the car fine. went for a little drive, came home, and it's now doing the same thing.
i have just purchased a J3 chip with the smart lock system bypassed/
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
gasdea |
|
|||
|
ok guys the chip didnt work.
this is doing my head in. any ideas?
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
TimmyA |
|
|||
|
you tried bumping the dash as I mentioned?
_________________ 93 Red ED 5spd Manual Build Thread |
|||
Top | |
gasdea |
|
|||
|
yeah mate, tried bumping the dash.
didn't work.
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
MAD |
|
|||
|
gasdea wrote: twase wrote: 60 minutes on an EL not 30....30 just gets it started not trained. thanks twase, i'm waiting it out now. so what will the smartlock light do when the hours up? MAD wrote: When you say "wont turn over" do you mean wont crank, or wont start? If you mean it wont crank, then it's not a smartlock problem. It will probably be your starter motor. With smartlock activated the engine will crank, but fuel (and spark I think) are cut. MAD, the engine will not turn over, like rotate. i dont think its the starter as it has a high qaulity aftermarket starter motor recently installed. plus the smart lock light is going off its head. Next time it happens, see if you can get to the starter solenoid and give it a bit of a tap with a hammer or something. |
|||
Top | |
gasdea |
|
|||
|
so the engine should crank even if the smart lock is up to s**t?
_________________ CHECK THIS s**t: LAWLZ |
|||
Top | |
MAD |
|
|||
|
Depends on what could be wrong with smartlock.
If, for example, your interior light fuse is blown, smartlock will be activated and will cut power to the fuel injectors. The engine will crank but will not start. If its a problem with the BEM I dont think the engine cranks over. |
|||
Top | |
TimmyA |
|
|||
|
or you just try swapping the BEM out for one that works (BEM & smartlock are one module on EF/EL)...
_________________ 93 Red ED 5spd Manual Build Thread |
|||
Top | |
Who is online |
---|
Users browsing this forum: Google Adsense [Bot] and 102 guests |