|
| yamum532 |
|
||
|
hi i was just wondering if i could get some info about my problem. i recently converted my ef gli 94 auto, to a manuel. all the parts used were from an ef xr6 including the computer. everything runs fine but for some reason the speedo is out. i also had a lsd centre put in but the diff gears are the same. also it had 179.5 rwhp with the auto with speed limiter. this computer doesnt have one. anyone with info on power gains from converting to manuel?
_________________ 10WEF - nolathane everything, xr6 interior manual gearbox and computer(no speed limiter). pedders sports ryder, pacemakers, 2.5" exhaust, heavy clutch, mild cam. 18 inch rims 265 rear tires
|
||
| Top | |
||
| phongus |
|
|||
|
manual will give you more at the wheels, but how much I am unsure.
Speedo might be out due to the speedo gear on the gearbox failing or not plugged in. phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| yamum532 |
|
||
|
alright. i also heard that some xr6 come out with 3.45 diff gears whereas mine has 3.23
_________________ 10WEF - nolathane everything, xr6 interior manual gearbox and computer(no speed limiter). pedders sports ryder, pacemakers, 2.5" exhaust, heavy clutch, mild cam. 18 inch rims 265 rear tires
|
||
| Top | |
||
| twr7cx |
|
|||
|
if your running the same ratio diff gears as you had before, but have installed a gearbox from an XR6 into a GLi, then I would say that you are running an incorrect speedo gear.
Did you swap them over when you swapped the gearboxs over? My guess is that you have the speedo gear for the XR's 3.45 factory diff, where you are running a different diff ratio, and therefore require the speedo gear that you had in your automatic transmission. as for power gains from converting to the manual - how longs a peice of string? depends on the individual car and set up as to how much gain. phongus wrote: Speedo might be out due to the speedo gear on the gearbox failing or not plugged in. This would more than likely cause the speedo not to be working, as opposed to displaying the incorrect speed as he has indicated above. yamum532 wrote: alright. i also heard that some xr6 come out with 3.45 diff gears whereas mine has 3.23
So my theory above is therefore correct. Last edited by twr7cx on Thu Jun 19, 2008 6:23 pm, edited 1 time in total. |
|||
| Top | |
|||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
179hp is a nice figure for an auto, so with manual add another 13hp roughly depending what condition the auto was in
Your speedo shouldnt be out if you used the original speedo cog, if theres problems with the wiring or gearbox cog it just wont work at all, but it wont change the frequency unless you have changed diff gears |
||
| Top | |
||
| phongus |
|
|||
|
twr7cx wrote: phongus wrote: Speedo might be out due to the speedo gear on the gearbox failing or not plugged in. This would more than likely cause the speedo not to be working, as opposed to displaying the incorrect speed as he has indicated above. Ahhh yeah...my bad...  
phong =P~
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| yamum532 |
|
||
|
so how hard is it to change the speedo gear? mite be better off putting the 3.45 diff gears in instead, my lsd needs a freshen up already anyway ha ha
_________________ 10WEF - nolathane everything, xr6 interior manual gearbox and computer(no speed limiter). pedders sports ryder, pacemakers, 2.5" exhaust, heavy clutch, mild cam. 18 inch rims 265 rear tires
|
||
| Top | |
||
| Gaz |
|
||
|
will take you all of 5 mins.
Still got the auto box? there is a red cable going into a small box near the rear of the gearbox, IIRC its an 8mm bolt or a simple philips screw holding it in, undo the screw/bolt and slide the gear out. The one you take from the auto will probably be green, get under the car and do the same on the manual box, they swap straight over.
_________________ 2007 Steel BF Ghia MKII V8 - 19" GTP's + Superlows |
||
| Top | |
||
| Krytox |
|
|||
|
Im sure this is the problem, you prolly have a black colored gear installed.
If theres still an issue, the worm gear on the output shaft could also be different, I doubt it, but I've heard of 2 types... however this could only be toyota boxes or holden, its been a while.
_________________ Carefree, we may not be number one, but we're up there. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 110 guests |
