|
theblackone |
|
|||
|
hey guys..
i got a 95 ef xr6 auto.. anyway i have this problem with my car, when im braking and come to a sudden stop, my rev gauge drops down to about 200rpm, and sometimes even stalls. I found this happens when its cold (as in the whether not engine temp) Also i was just testing some stuff out, and i put it in nuetral whilst idling and sometimes it just stalled. Basically when under braking it feels like its going to stall, then suddenly gets its revs back up to about 800rpm or sometimes stalls. what should i be looking at here. thanks
_________________ SIGNATURE REMOVED - REFER TO FORUM GUIDELINES! |
|||
Top | |
KTASTRPHE |
|
|||
|
clean out your throttle body with carby cleaner. Make sure your air filter is clean/new. Make sure all your vacuum lines are connected.
If it still happens after this it could be a faulty throttle position sensor - I think they are around $40. |
|||
Top | |
rushed |
|
|||
|
clean your isc, useually these problems are related to it.
its the thing on top of your t/body pull it off and clean, i cant remember what with though, sure someone will tell you. i did the cardboard "solid" gaskit for it essentially disabling it and wound the idle screw in more, better throttle responce. |
|||
Top | |
GTBob |
|
|||
|
The only problem with that is COLD start on a VERY cold morning
_________________ Rotten Old Revhead!!! XW GTHO + EF ex cop car (exractors 2.5 cat back zorst !6" Simmons K&N +airbox mods Lowered with Bilstein shocks+Whiteline Bars NEXT THING Swap HO for GTP or Ferrari! |
|||
Top | |
paul3518 |
|
||
|
also have a look at the distributor and coil if your ef has one.had the same problems with my el fairmont and ed xr6.replaced coil and distibutor and it stopped
|
||
Top | |
MARK.TANIA |
|
||
|
also cheak if you inlet bolts are loose
|
||
Top | |
theblackone |
|
|||
|
{USERNAME} wrote: clean your isc, useually these problems are related to it.
its the thing on top of your t/body pull it off and clean, i cant remember what with though, sure someone will tell you. i did the cardboard "solid" gaskit for it essentially disabling it and wound the idle screw in more, better throttle responce. i think there is a doco on that.. ill check that out first gonna get my car tested for noise emissions. then ill have a go at it thanks guys
_________________ SIGNATURE REMOVED - REFER TO FORUM GUIDELINES! |
|||
Top | |
mendyxr6 |
|
|||
|
i kinda had the same problem with my car chech the injectors are all working cause one one mine had stuffed up
_________________ kangaroos and radiators are a bad mixture |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 43 guests |