|
| fritz |
|
||
|
Hi,
has anyone removed the sump off of an ef I6 while the motor is still in the car..can it be done???? |
||
| Top | |
||
| EFFalcon |
|
|||
|
2 options.
drop the kframe (what i intend to do *TODAY*) or lift the engine out a bit to give it clearance. i'll go the kframe 
_________________ FALCN6 - EF GLi Turbo, 20" Rims, Air Bag Suspension, Straight LPG, 225rwkw |
|||
| Top | |
|||
| Dellboy999 |
|
|||
|
EFFalcon wrote: 2 options.
drop the kframe (what i intend to do *TODAY*) or lift the engine out a bit to give it clearance. i'll go the kframe lift the engine up (engine mounts undone), you have to lift the engine a fair way up and even then it wont come out without removal of radiator, front bumper, move/slide/angle the a/c condensor etc out of the way, and then the sump will just come come out. so remove engine complete with gearbox (its easier that way really) and then you can do gearbox seals and rear main seal on the engine as well), or drop the k-frame and just do the sump.
_________________ Full working BA Shifter now upgraded to BF Shifter. |
|||
| Top | |
|||
| FastFutura |
|
|||
|
hmm thinkin thats the best way, (my mates ef has leaky sump gasket.) so k frames a f**k easier to do than engine removal? are their any mounts on the k frame (would you need to jack up engine to allow frame to be removed?)
_________________ 94 ED Futura, 5spd, RPM clutch,3.27 LSD, PH4480 pacemakers, 2.5'' Supercat, STG 2 Wade1004-112 advanced16degrees, XH intake K&N panel,pedders superlows, Expursuit puter. clearindicators, volvoTT thermofan
|
|||
| Top | |
|||
| Jaysen |
|
|||
|
its to my understanding that the K frame also supports the front lower control arms and the engine mounts, so if you remove it whats going to hold your engine up and you will need to realign your front end when you refit it
_________________ Dima, Mitch & Jay's RPD |
|||
| Top | |
|||
| BigBlu |
|
||
|
Yes im sue the mount are ont the K frame and i think the rack is too. It would be similar to a VN SS i think u could use those frames that sit on the gards and hold the gear box up i supose u could ty and use it to support the engine
_________________ There is no substitue for cubic inches! |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: Google Adsense [Bot] and 71 guests |
