|
Hybrid34 |
|
||
|
Hey all,
I've tried to search this problem on the forum, and as i think its the lifters,...I get this VERY loud ticking noise from my car, everytime I give it a bit of gas, say going through 1st n 2nd gear pretty hard...everyother time theres no noise at all, only when its under hard acceleration,... why would it be making this noise? and what should i do about it? Lifter Treatment? thanks - Ash
_________________ Sucessful trades with Schmee, Braidy, Niko, The_Ghost, YBHVE4, Stalker
|
||
Top | |
SgtBourne |
|
||
|
didnt search too hard i dont think.
yes it's probably the lifters if it increases with RPM. thing i can suggest, have you checked your oil level? top it up.
_________________ So much RAM the motherboard twisted off the POST. |
||
Top | |
Hybrid34 |
|
||
|
well thats the thing, I did a search and found a heap on lifter noise, getting it when the car starts up, or gradually over time it starts to increase in volume..but i only get a VERY loud ticking noise when I put my foot down,
I use Penrite HPR-30 and only did it around 3000kms ago, - Ash
_________________ Sucessful trades with Schmee, Braidy, Niko, The_Ghost, YBHVE4, Stalker
|
||
Top | |
Dansedgli |
|
||
|
Can you hear it all at idle?
|
||
Top | |
Luxo Sprint |
|
|||
|
tourque converter bolts may have come loose it sounds like a tickin/knocking sound
open the inpection plate on the tranny and see if there loose |
|||
Top | |
MooseMan |
|
|||
|
Mate had the same problem. Eventually was a cracked timing chain cover...
_________________ |
|||
Top | |
Hybrid34 |
|
||
|
MooseMan wrote: Mate had the same problem. Eventually was a cracked timing chain cover...
:s that doesn't sound good... Thing is its not at idle, or normal driving...only when I give it some.. Is there anything I can do about it?
_________________ Sucessful trades with Schmee, Braidy, Niko, The_Ghost, YBHVE4, Stalker
|
||
Top | |
FLASH |
|
|||
|
Had a similar problem with my EB no ticking at idle but came on more and more with revs... ended up being a cracked drive plate! it had split between all the bolts except one! i think the torque converter may have lost a balance weight but there was no vibes? hence im glad i caught that one in time!
_________________ FALCAHOLIC |
|||
Top | |
creeture3 |
|
||
|
Check converter bolts, they can come loose.
Piston slap?? |
||
Top | |
Hybrid34 |
|
||
|
ahh, would it be serious? only does it over 3,000rpm and its pretty loud, espeically if i give it a squirt..
_________________ Sucessful trades with Schmee, Braidy, Niko, The_Ghost, YBHVE4, Stalker
|
||
Top | |
MadMatt |
|
|||
|
Loose bolts = inspection plate off, tighten bolts and refit inspection plate.
Cracked drive plate = Remove trans, Replace drive plate and refit trans. I would check it asap. If you are lucky, you will catch it before you crack the drive plate.
_________________ Member Number 8804 |
|||
Top | |
Who is online |
---|
Users browsing this forum: Google [Bot], Google Adsense [Bot] and 2 guests |