|
madeaspack |
|
||
|
but realised the old magna sitting out the back has 2 thermos a 12 and a 10 inch,painted them black and they dont look too bad,not as good as a ef setup looks but not totally s**t!Should i just put these in instead to save money,or will they not be as efficient??
cheers chris
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
Top | |
falconea |
|
||
|
It will depend on how much trouble it will be to fit them to the radiator also how u can control them.
You can always put them on and if they dont do the job then fit Ford ones. Suggest if possible to use ford relay setup so changing to ford fans will be a snap. You can use a JAYCAR temp kit to control them.
_________________ Drive safe, arrive alive
|
||
Top | |
madeaspack |
|
||
|
how do ya mean to use the ford relay setup??
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
Top | |
falconea |
|
||
|
Ford use 3 or 4 relays to control thier fans depending if they are from an EF or EL. So you need to look at what controls your fans and see if it can be used on the Ford. If not see if u can use the Ford setup on your fans.
_________________ Drive safe, arrive alive
|
||
Top | |
madeaspack |
|
||
|
all i know is it has a coolant temp sensor in the lower tank of the radiator that the wiring from one of the fans goes to!iv got a new temp switch thing and was gonna try to figure out how to wire it up!i dont have bbm manifold or el ecu!how would you recommend i go about it?
_________________ 97 el xr6,5 speed short shifter,sequential scoop,no arial,freshly resprayed,low on 17's,3 inch zorst,stainless hi flo cat,snort stage 3 stainless manifold,garrett t04e,front mount cooler,wolf 3d ecu,seimens 760cc injectors,walbro fuel pump |
||
Top | |
falconea |
|
||
|
Personally I would get the Ford fans and relays complete with wiring loom and use the Jaycar temp kit $29.95 to control it. You can set it so the fans come on to suit u.
_________________ Drive safe, arrive alive
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 82 guests |