So I took the old one off when I was taking my engine out, and now I'm putting all new hoses in, but I cannot find where this goes now..

Help pleasee

Runs from the heater core to the heater tap... Drops down under the intake manifold... Then the hose from the other side of the tap runs up to the thermostat housing...

Cheers,
Tim

Are you talking about this one?

Ahhhh... Na I think it's the one close to the motor... I think... Right next to the one in the middle of your circle...

The one you circle is funny shaped and drops straight down and then does a big sweeping u turn back up in into the special plastic connector which clips onto the steel pipe which runs around the back of the motor to the water pump (water leaves the heater core through this pipe)...

The one you are looking for, follow the steel pipe out of the thermostat housing, it turns into rubb hose which ends up at the plastic heater tap down near the starter motor and then comes out of the heater tap into the hose you pictured up and up into the heater core (water inlet to the heater core)...

Make sense?



This is my donk... See the one further away from the motor does the u turn into the steel pipe which goes around the back of the motor... One closer drops down and I don't run a tap so there is just a brass joiner in the rubber hose which then runs to the steel pipe (which isn't fitted into the thermostat here, just hanging in the breeze)...

Cheers,
Tim

Thanks heaps Tim,

I had an extra 3rd hose.. which came with my motor, and I had seen it'd been taken off already. So I had this new hose and no where to put it because I hadn't even taken the old one out of the engine bay.. haha

No worries mate...

The mystery of the extra hose has been solved...

Enjoy!