|
| nare |
|
||
|
Would it be possible? What would be needed (other than the engine, duh!)?
Also would a stock auto hold up? |
||
| Top | |
||
| Disco Frank |
|
|||
|
hey dude welcome to fordmods!
this has been convered b4, yes it will fit but u will need a lot of work for it to run ie full aftermarket ecu ie motoec is about the the only thing u will find can run the engine thats about 6k then there is the engine itself not sure on cost but over 6k again i would assume also the stock auto would need beefing up! be cheaper and easier to turbo the car u have now
_________________ RIP SCOTT |
|||
| Top | |
|||
| He[X]eN |
|
|||
|
Disco Frank wrote: hey dude welcome to fordmods!
this has been convered b4, yes it will fit but u will need a lot of work for it to run ie full aftermarket ecu ie motoec is about the the only thing u will find can run the engine thats about 6k then there is the engine itself not sure on cost but over 6k again i would assume also the stock auto would need beefing up! be cheaper and easier to turbo the car u have now Was quoted from a Ford service centre 16k for the engine! 
_________________
|
|||
| Top | |
|||
| chunkz |
|
|||
|
if your gunna spend that much, may aswell go all out and try for a 6 speed conversion
_________________
|
|||
| Top | |
|||
| Bomber |
|
|||
|
need new bonnet or bonnet bulge might not fit near firewall, i looked at this option and gave up pretty quick its just not worth the $$$
|
|||
| Top | |
|||
| xr8 dismantler |
|
|||
|
i can supply the motor & auto with all the looms and P.C.M
for $7500 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 69 guests |
