|
| efun |
|
||
|
Ok so my window used to stop 3/4 down and then id just keep flicking up and down and it'd usually go down or up... but when i got to my car after dinner tonight this happened... loud noises when the window stops..
 can someone help me? would it just be the switch or?? sounds like somethings being jammed... here's a video of it: http://www.youtube.com/watch?v=i9FHITYotb4 what should i do?
_________________ Holden = Hope Our Luck Doesn't End Now |
||
| Top | |
||
| BAXLS03 |
|
|||
|
Get some silicone spray and spray the rubbers! And stop trying to use it or you will f**k the motor! lol
It's because the glass is binding on the rubber. |
|||
| Top | |
|||
| efun |
|
||
|
ohh haha do i need to open the door trims and spray the rubbers or just spray them from the opening from where the window is?
_________________ Holden = Hope Our Luck Doesn't End Now |
||
| Top | |
||
| BAXLS03 |
|
|||
|
Put the window down and spray around the rubber you can spray down the track a bit, shouldn't have to pull the trim off. Might have to run it up and down a few times.
You can also get a rag and a flat head screw driver, wrap the screw driver with the cloth and run it around the slot. It will clean the gunk out and then spray it again. Should work like new. |
|||
| Top | |
|||
| efun |
|
||
|
thanks! will give it a shot today.
_________________ Holden = Hope Our Luck Doesn't End Now |
||
| Top | |
||
| efun |
|
||
|
ok it didnt work
sprayed it all in there and now my window is all the way down and isnt coming up ... keeps making that noise HOW TO PULL APART TRIMMING? so i can get it up...
_________________ Holden = Hope Our Luck Doesn't End Now |
||
| Top | |
||
| BAXLS03 |
|
|||
|
Well you must have fingered the motor using it when it was sticking. 2 screws top corner edges of the trim, 1 screw in the handle, 2 in the grab handle and 2 down the bottom. Then just pop it off...
|
|||
| Top | |
|||
| efun |
|
||
|
yeah i opened the trimmings figuring it out myself.. wasnt anything too hard, i managed to get the window back up thankgod! but now i just got off the phone with ford and they say it's $199.95 for a new regulator and charge $132.85 PER HOUR (labour charge)
that's $332.8 .... is this right? i want to fix it myself but i just wanted to call ford to see what im looking at if i dont have the time to isntall it myself.
_________________ Holden = Hope Our Luck Doesn't End Now |
||
| Top | |
||
| BAXLS03 |
|
|||
|
Never had to replace one but i would suggest that it wouldn't be hard. http://cgi.ebay.com.au/Ford-AU-BA-BF-Fa ... 27b245f6fb
|
|||
| Top | |
|||
| efun |
|
||
|
thanks BAXL for tips and the link!
 and thankyou ash for the instructions i shall purchase that regulator next time and fit it in! cheers 
_________________ Holden = Hope Our Luck Doesn't End Now |
||
| Top | |
||
| BAXLS03 |
|
|||
|
No worries mate.
Cheers Paul. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 12 guests |
