|
| B0XCAR |
|
|||
|
howsie wrote: us audio made a good one not sure if they still do was about $400 to $500 and was a 4ch 75wrms per channel so each sub would have 150WRMS which is all most subs can handle. Other than this alpine typeX 1000WRMS
 Although i think these are a little pricy. i'm not sure but i think they were $800 Haha The Kicker L7 is 750RMS WATTS not 150RMS WATTS  would finda Stuff the sub up
|
|||
| Top | |
|||
| howsie |
|
|||
|
thats 150WRMS each sub if you have 2 subs
_________________ Current cars |
|||
| Top | |
|||
| B0XCAR |
|
|||
|
howsie wrote: thats 150WRMS each sub if you have 2 subs
no thats 1500Watt rms if i had 2 of em 
|
|||
| Top | |
|||
| howsie |
|
|||
|
Ford-sxr6 wrote: howsie wrote: thats 150WRMS each sub if you have 2 subs no thats 1500Watt rms if i had 2 of em Ok first an underpowered sub is preferable to a overpowered one its overpowering a sub that kills it. Obviously you try to match rms rating as close as possible. I think there is a misunderstanding i was saying that the amp would be putting out 150WRMS to each sub not 150WRMS for the sub itself. http://discountpowerparts.com/catalog/p ... ts_id=1344 this link is for a nice fusion monoblock that might be worth considering if you have the money, not sure of the price but i imagine it'll be expensive
_________________ Current cars |
|||
| Top | |
|||
| krisisdog |
|
|||
|
Get a 2nd hand Alpine MRD M1000 to M1005.
Will cost 200-500 depending on model, but is an absolutely fantastic amp. Digital tuning & readouts, and its build quality is fantastic. |
|||
| Top | |
|||
| B0XCAR |
|
|||
|
nah im lookin for a 750 watts rms or a 1000 watts rms (then turn the gain a lil down)
thats over powering it by like nearly double
|
|||
| Top | |
|||
| krisisdog |
|
|||
|
howsie wrote: Ford-sxr6 wrote: howsie wrote: thats 150WRMS each sub if you have 2 subs no thats 1500Watt rms if i had 2 of em Ok first an underpowered sub is preferable to a overpowered one its overpowering a sub that kills it. Obviously you try to match rms rating as close as possible. I think there is a misunderstanding i was saying that the amp would be putting out 150WRMS to each sub not 150WRMS for the sub itself. http://discountpowerparts.com/catalog/p ... ts_id=1344 this link is for a nice fusion monoblock that might be worth considering if you have the money, not sure of the price but i imagine it'll be expensive Nah buz, its not overpowering, its sending the sub a clipped signal - DC current which burns out the core. I think you'll find most subvs are rated at far greater than 150rms, the cheapie $100 Pioneers are 400rms +. My sub is 750rms, and is being run off the Alpine Monoblock I mentioned at 1000rms, but its getting a clean signal, with the gains set to 0 (digital setup, completely different to dials). For the Kicker you'll need at least 750rms, if not far more. If you opt for a higher rms amp, and tune it correctly it will be working less than a lower rated rms amp to produce the same rms. This means your amp will last longer because its running cooler and is not straining. Always over spec your amps - Just be sure you can tune them properly. |
|||
| Top | |
|||
| B0XCAR |
|
|||
|
Yea wat he said
i was lookin at the alpine amps i mite end up gettin one of them of the one that kicker made for the sub dunno yet gotto get some me $$ up first
|
|||
| Top | |
|||
| krisisdog |
|
|||
|
Just because its the same brand doesnt mean it was made for the sub, or anything at all really.
I'd put the high end alpine gear above anything from kicker. |
|||
| Top | |
|||
| B0XCAR |
|
|||
|
Yea i will put alpine above all the brands out there.. and i kno its not made for the sub but it has the right power i need for the sub and it means less f**k around but i did say i was looking at the alpine monoblock
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 32 guests |
