|
ToranaGuy |
|
|||
|
{USERNAME} wrote: The tweeters in the factory premium system us a resistor (at least I think they are a resistor) mounted on the body of the tweeter as a cross over, so don't bother looking for a crossover anywhere else!
That's all i was expecting to find, considering they are factory tweeters. I'll have to look the specs of my HU up and see if there is an issue wiring like what has been sugested. Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|{DESCRIPTION}|{DESCRIPTION}|{DESCRIPTION}| |
|||
Top | |
MadMatt |
|
|||
|
I have the speaker for my UHF up there.
_________________ Member Number 8804 |
|||
Top | |
ToranaGuy |
|
|||
|
{USERNAME} wrote: I have the speaker for my UHF up there.
Cool. That reminds me, i've got a cb lying around somewhere, was to go into my panel van, i should probably put it into my ford to get some use from it, pano is a while away yet. Cheers ToranaGuy
_________________ I am the ToranaGuy!|74 Lh Torana Turbo|78 Hz PanelVan|86 Mighty Boy Ute|93 EB2 Ghia,GT Mockup,5spd,LPGI,Full Leather|2 x EB Xr8 5spd's|{DESCRIPTION}|{DESCRIPTION}|{DESCRIPTION}| |
|||
Top | |
FORD-FirstOnRaceDay |
|
||
|
Does anyone have any instructions and or pictures on running new wires from the door speakers to the factory tweeter location? My new tweeters connect to the front door speakers and run through to the dash but I'm not sure of the easiest / best way to do this? Thanks in advance!
|
||
Top | |
outlawxr6 |
|
|||
|
I put my tweeters in the sail panel, I tried them in the stock locations but hated the result, the drivers side was much stronger then the passenger side, now it's nice and even, best so far that I have tried in it.
With 10" midbass in the doors it's hard to be subtle though!!! {DESCRIPTION} {DESCRIPTION}
_________________ Do it once, Do it right!!!!!! |
|||
Top | |
FORD-FirstOnRaceDay |
|
||
|
{USERNAME} wrote: I put my tweeters in the sail panel, I tried them in the stock locations but hated the result, the drivers side was much stronger then the passenger side, now it's nice and even, best so far that I have tried in it. With 10" midbass in the doors it's hard to be subtle though!!! {DESCRIPTION} {DESCRIPTION} Did you make those pods for the tweeters or did you buy them mate? They look good! |
||
Top | |
outlawxr6 |
|
|||
|
I made them from a spare pair of trims with a piece of shaped MDF glued to the front, filled the edges with bog and finished so they were smooth and trimmed in vinyl....
_________________ Do it once, Do it right!!!!!! |
|||
Top | |
FORD-FirstOnRaceDay |
|
||
|
Could you make me a set and post them to me? Haha
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 39 guests |