|
frd_xr6 |
|
||
|
The remote wire from my headunit to amp is dodgy and causing my amp not to turn on, so i need to run a new wire.
Now my question is how do i get the existing wire out of the plug/loom thing that all the wires go into then connect to the back of the headunit? I cant figure out how they unclip or however they are held in there? As you can see im not very technical when it comes to this stuff
_________________ 1996 5spd EF2 XR6 - Genuine AJR's, full kit........ |
||
Top | |
Interceptor |
|
||
|
why not just tap into the wire where it goes into the plug?
_________________ Banned |
||
Top | |
frd_xr6 |
|
||
|
I was thinking that but not sure if its that end thats the problem?
I couldnt be bothered taking out the headunit to check that until i know how to put the new wire in the plug just in case that is the problem, im lazy
_________________ 1996 5spd EF2 XR6 - Genuine AJR's, full kit........ |
||
Top | |
kermey |
|
|||
|
Gopher's are soooo lazy
|
|||
Top | |
Happy |
|
|||
|
worse than Oompa loompa's
_________________ Owning 1 of 67612 EF GLi Sedans made
|
|||
Top | |
frd_xr6 |
|
||
|
Damn you people wheres my answer! Now this lazy gophers off to try interceptors idea, as long as he can find those wires...
_________________ 1996 5spd EF2 XR6 - Genuine AJR's, full kit........ |
||
Top | |
frd_xr6 |
|
||
|
All is good just tapped into the existing wire near the plug and ran the new wire, now with bass again
_________________ 1996 5spd EF2 XR6 - Genuine AJR's, full kit........ |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 25 guests |