|
| nicco |
|
|||
|
Since i have lowered the car, the headlights have been... well... s**t!!
so i need to lift them up a little bit to get some distance in front of the car happening again. But, i cant work out how to do it. Thanks Nicco |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
pop the bonnet
ahve a look were your lights are in the engine bay u should see some plastic knobs 2 per side i think ... these will alter angle up/down and left right find a nice straghit piece of flat desserted rd at nite cover 1 headlight up and then adjust the other. and vice versa also make sure u DONOT point the beams straight ahead u want a small angle to the left and down
_________________ RIP SCOTT |
|||
| Top | |
|||
| drinkman |
|
|||
|
Just went throught this excercise last week. I found the up down knob, you cant miss it, its right next to the removable cover for the globes. But I couldn't find a left right knob, any hints on precise location.
|
|||
| Top | |
|||
| Disco Frank |
|
|||
|
the other side of the headlight...
sometimes can be a s*** to find and move 
_________________ RIP SCOTT |
|||
| Top | |
|||
| twirqurky |
|
||
|
Whata bout XR ones Frank, any ideas on htem? I need to raise low beams and lower high beams.
|
||
| Top | |
||
| Mechan1k |
|
||
|
{USERNAME} wrote: Just went throught this excercise last week. I found the up down knob, you cant miss it, its right next to the removable cover for the globes. But I couldn't find a left right knob, any hints on precise location.
literally inside the guard on the aftermarket headlights ... there's a hole in the top of the radiator support right at the edge of the bonnet line ... you need a screw driver pointed down on an angle (pointing away from the engine - sideways) ... till you find the screw adjuster. turn till it goes the way you want.
_________________ 04 Territory TX AWD - Winter White - optioned up |
||
| Top | |
||
| nicco |
|
|||
|
So that big bertha orange knob on the back of the light is the up down adjustment and the little screw on the top of the light but down by the guard is the left/right adjustment
mkay i will try that tonight |
|||
| Top | |
|||
| XCH45R |
|
|||
|
haha, i had to do exactly this last week, any idea how the light beams should go? I heard the left should be a tad higher than the right? and they both shouldent be straight on sorta thing?
|
|||
| Top | |
|||
| nicco |
|
|||
|
i am figuring that i will just lift them straight up
ford, you would hope, would have got the side to side bit right i know that before the light beam on mine was \___ if that makes sense lol. it kicks up a bit on the left |
|||
| Top | |
|||
| XCH45R |
|
|||
|
yeah same.. u dont wanna know how mine got un ajusted.. stupid woman!
 lol
|
|||
| Top | |
|||
| Disco Frank |
|
|||
|
{USERNAME} wrote: Whata bout XR ones Frank, any ideas on htem? I need to raise low beams and lower high beams.
no idea on the ef/el range au's are easy 4 big orange coloured knobs
a good setup for your lighst is point slightly off centre to the left and down( stops lighst going into oncoming cars ) and you want the light to be around 30mtrs infront of car ( low beam ) and high beam from the 30mtrs onwards if u set your lights up got for a drive at nite... if u dont liek it change em
_________________ RIP SCOTT |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 20 guests |
