|
| kevau99ben |
|
|||||
|
Hi Guys
I am looking at using mesh in the front grill similar to pic , has any body done this mod ? What type of mesh would be best suited , and method of securing mesh to grill Thanks in advance Kevin
|
|||||
| Top | |
|||||
| frd906n |
|
||
|
when i had the same grill before i changed bonnets i bought the mesh from auto barn as they were cheaper then,
i just measured the width and length of the hole and left about 20mm over hang all around and bent the sides over and used liquid nails to hold it in place, worked a treat
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| kevau99ben |
|
|||
|
thanks , sounds the way to go
|
|||
| Top | |
|||
| Papa Smurf |
|
||
|
I like that Grille and I think it will look good on any AU1.
|
||
| Top | |
||
| kevau99ben |
|
|||
|
Yes it looks the part , should have been standard from introduction of series 1
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 37 guests |
