|
00sproggles00 |
|
||
|
|||
Top | |
Fordsrule174 |
|
||
|
arnt these just vinyl ?
if so just steam should remove them if they are painted on then good luck with that lol
_________________ NF Fairlane Ghia, Brand New Leather Interior, Wallnut All Through, 800W RMS JL Audio Sound System, Lowered King Springs And Monroe GT Shocks, Custom BA/GT Air Intake, Holley Highflow, Simmons B45's, Going To Be Supercharged At 9-12psi With Stage 4 Head And Cam With Pacemakers And 3" Exhaust |
||
Top | |
KWIKXR |
|
|||
|
I heated mine up slightly with a hair dryer, then peeled/scraped it off with my fingernail. It worked okay lol
|
|||
Top | |
00sproggles00 |
|
||
|
KWIKXR wrote: I heated mine up slightly with a hair dryer, then peeled/scraped it off with my fingernail. It worked okay lol thanks ill give it a go |
||
Top | |
Benny D |
|
|||
|
i used a little steam dream thingo to get the pin striping off my el.
then goo remover for the excess glue. ezy as.
_________________ BA XT V8. Ice Mint. 18" Speedys. XR6T LSD. Full Pacemaker twin 2 1/2inch Stainless Steel system. Custom CAI. Black XR interior with white trimming. Powerbond underdrive kit 25%. |
|||
Top | |
dazza027 |
|
||
|
Bet your EL's towed a few caravans in its day. Proper old mans classic there.
|
||
Top | |
TimmyA |
|
|||
|
I went and seen the smash repairs joint here and the loaned me an eraser wheel...
Looks identical to this... http://cgi.ebay.com.au/MOULD-GLUE-REMOV ... 27b916ae0c I put it in a cordless drill... Lowest speed setting... and hold it down on an angle and just crank the drill over slowly and it'll take it straight off... Basically the wheel is like a rubber eraser for lead pencil... the rubber grabs the pin stripe and take it off... Its so handy I bought myself one... BE AWARE IF YOU GO TOO FAST WITH THE DRILL YOU CAN MELT THROUGH THE PAINT... ITS TIME CONSUMING BUT SLOW AND STEADY WINS THE RACE WITH THIS METHOD... Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
Top | |
wolfblass |
|
||
|
i used a hair dryer and a plastic scraper, came off in like 5 mins in one piece. just be careful not to heat the paint up.
|
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 64 guests |