Fordmods Logo

Ford Falcon AU 2000 Series II 

 

Page 2 of 2 [ 18 posts ] Go to page Previous  1, 2

 
 Post subject: Re: Ford Falcon AU 2000 Series II
Posted: Thu Sep 23, 2010 9:37 am 
Getting Side Ways
Offline

Age: 34

Posts: 747

Joined: 8th Nov 2009

Ride: ford au

Location: brisbane
QLD, Australia

but yeh mate, thats what im doing with my 99 au ford, ameretto mett or wateva it is, finding good condition and straight panals and putting them on, dosent worry me about the paint condtion as it will get a respray anyways

at one stage before my bingle it was very straight, no dents or anything, and they were gonna charge me around the 2 o 3 grand mark, because i went out and replace the dented panals and s**t

 

_________________

Daily Driver, Series 1 Au Forte

Quote:
Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors

Top
 Profile  
 
 
 Post subject: Re: Ford Falcon AU 2000 Series II
Posted: Thu Sep 23, 2010 11:52 am 
Getting Side Ways
Offline

Posts: 6113

Joined: 8th May 2007

sand the s**t out of it till all the flaking clear is off

then take your paint code into a spraypainting shop (paint code is on the id plate in the engine bay) and get them to fill a few spray cans up with your colour

then prep the surface, spray the colour, spray with clear, then after a few days rub back with 2000grit wet and dry, then a good cut n polish

its not worth paying someone to do it, as im sure you dont want to spend more than what the car is worth for professional paint
Top
 Profile  
 
 
 Post subject: Re: Ford Falcon AU 2000 Series II
Posted: Thu Sep 23, 2010 12:18 pm 
Getting Side Ways
Offline

Age: 65

Posts: 1128

Joined: 13th Sep 2010

Ride: Ford Falcon AU 2000 Series II

Location: Crestmead
QLD, Australia

Thanks for the tip.

Yeah I'm going to do it myself and give it a go.

How many coats of paint you reckon, 4 litres of 2K shold do the trick.

I got use of an air compressor and have spray gun.

What is a good cut n polish to use?

Cheers
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 2 of 2  [ 18 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 20 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Wed Dec 25, 2024 1:10 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names