I have swapped over the standard lights /front end of my EB2 Monty to an XR front end twin spots. Connected the looms all in place all seems to work o.k, however when I put on high beam - the dips drop out? However if I use the Pass mode (pull back the lever) All lights come on?? Solutions please. Cheers

You have to modify wiring.
If you have a manual it will show diff.
If you don't then PM me for details
Grumbles

Thanks will PM ya - Cheers

Hello,

Based on a 93 ED Falcon

procedure is... under black cover beside battery attached to mudguard is 4 relays... 1 yellow 3 grey... the middle grey is the low relay...

this 4 pin relay needs to be exchanged with a 5 pin commonly blue relay that has an "87a" contact in the centre...

under the header tank there is an empty clear plug t arrangement with two female spade contacts in it... from my schematics I have traced out you can either buy this yellow fuse (which i have heard about but not seen yet) or just straight bridge it out with a wire link (make sure wire is of heavier gauge to take both the low beams current...

now the lows come on with the low... and both when the contacts are changed over to the high relay...