|
eattsie9 |
|
|||
|
so my passenger side headlight is all fogged up and it has been since the first time i washed it and i guess all this rain isnt helping
im assuming its due to water leaking in somewhere but theres no obvious cracks so i was just wondering is it a fixable problem or am i going to need to buy a whole new headlight :S
_________________ Ba Xr6 Boat |
|||
Top | |
phil545 |
|
|||
|
the rubber boot on the back is firmly in place and the hole in it surrounds the bulb so its a tight fit?
_________________ I hate arriving at my destination as then I have to get out of my car! |
|||
Top | |
Disco Frank |
|
|||
|
{USERNAME} wrote: the rubber boot on the back is firmly in place and the hole in it surrounds the bulb so its a tight fit? have this with my au all good and water still gets in pulled the lights off and drilled a small hole in the bottom to allow water to drain so far so good!
_________________ RIP SCOTT |
|||
Top | |
my671fordv8 |
|
|||
|
You may need to re-seal your headlight with butyl rubber glue. You need to use a leat gun to pull the lens off and put the glue in the slot heat it up and reseal it
This is what you are looking for but you can probably get it here in Australia http://www.theretrofitsource.com/produc ... cts_id=792 |
|||
Top | |
phil545 |
|
|||
|
I ended up cutting the rubber boot a bit to fit around the hid globe, you dont want any moisture getting in otherwise the reflector sort of goes cloudy and then u gotta clean it wiv ur finger, not, not to mention your haverdrive
_________________ I hate arriving at my destination as then I have to get out of my car! |
|||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 47 guests |