|
| Leroy |
|
||
|
would of been easier to do before you put it on the car too
_________________ Now driving a Hilux |
||
| Top | |
||
| Rick_Deckard |
|
|||
|
{USERNAME} wrote: would of been easier to do before you put it on the car too
Lol dude, read above the picture. It was just sitting there. Right now they are sitting in the back yard with their 2nd coat of clear. Is the cutting bit reallyyyyyy necessary?
_________________ E39 523i |
|||
| Top | |
|||
| Leroy |
|
||
|
ahhh sorry. i didnt read that bit
if you want it to look like the rest of the car then yes, you will have to do a few coast of clear then wait til it cures and cut it back.
_________________ Now driving a Hilux |
||
| Top | |
||
| Rick_Deckard |
|
|||
|
Argh, how long does this "cure" take?
_________________ E39 523i |
|||
| Top | |
|||
| twr7cx |
|
|||
|
{USERNAME} wrote: Argh, how long does this "cure" take?
As said, leave for a few days, I leave for a week. You can fit them to the car when dry, just cut them when there on the car. |
|||
| Top | |
|||
| Rick_Deckard |
|
|||
|
Well I did it, but not after cutting my fingers twice with a stanely blade while trying to remove old tape, cut pretty deep too.
Here it is completed, may cut it at a later date. If compared with a clean part of the car, it does look right. 
Thanks for the help guys.
_________________ E39 523i |
|||
| Top | |
|||
| boost1105 |
|
|||
|
haha first u lock urself in the boot now you slice your fingers, what next car falls off the jack and pins you to the floor LOL
good work |
|||
| Top | |
|||
| Mash85 |
|
||
|
{USERNAME} wrote: haha first u lock urself in the boot now you slice your fingers, what next car falls off the jack and pins you to the floor LOL
good work dont give him ideas...
_________________
|
||
| Top | |
||
| fairmont599 |
|
||
Posts: 1135 Joined: 27th Oct 2005 |
they look almost a purple colour when compared to the rest of the car...
|
||
| Top | |
||
| Rick_Deckard |
|
|||
|
I'll give her a wash tomorrow hopefully, then we'll see how it looks. Plus I haven't cut it yet, so that might make all the difference.
_________________ E39 523i |
|||
| Top | |
|||
| Holbrookau |
|
|||
|
Definatly doesn't look a good color match (sorry!). Are you sure the paint was mixed (shaken) enough?
Did you get the paint custom mixed into a spray can? Given the cost you quoted, one could assume so - I would be asking for a replacment.. A tip for spraying in cooler conditions is to sit the spray can in hot water for 5 mins before shaking it up for a least the recommended 2 mins - good gloss "of the gun" is very acheivable particularly if you warm the part to be sprayed in the sun or near a heater for awhile. One thing to note - over time, painted plastic body parts tend to change color slightly and if you respray an adjacent part the differnce is very noticable.
_________________ '94 EF GLI
Last edited by Holbrookau on Fri Aug 04, 2006 12:03 am, edited 1 time in total. |
|||
| Top | |
|||
| Mitch_ |
|
|||
Posts: 6168 Joined: 5th Nov 2004 |
{USERNAME} wrote: I'll give her a wash tomorrow hopefully, then we'll see how it looks. Plus I haven't cut it yet, so that might make all the difference.
try not to drown 
_________________
|
|||
| Top | |
|||
| phongus |
|
|||
|
{USERNAME} wrote: haha first u lock urself in the boot now you slice your fingers, what next car falls off the jack and pins you to the floor LOL good work lets hope that doesnt happen cause i don't think that would be funny...... however..... {USERNAME} wrote: Till_Lind wrote:
I'll give her a wash tomorrow hopefully, then we'll see how it looks. Plus I haven't cut it yet, so that might make all the difference. try not to drown icon_razz.gif is funny hahaha looking good there mate but as someone said up top....the paint seems to be out of place.
_________________ phongus = Post whore 2006 |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 15 guests |
