|
| xr8p200 |
|
||
Age: 39 Posts: 16 Joined: 8th May 2009 Ride: AU II XR8 UTE Pursuit 200 Location: Browns Plains |
Hey all, stripping my front bar which has had crap spilt all over it and is peeling the paint. In spots that it rubs through to the plastic do i have to put plastic primer on it or can i just use normal primer? or should i strip the whole bar back to plastic and start from sctratch? The damage is only to about 1/3 of the bar.
Cheers guys Lachlan |
||
| Top | |
||
| jonathon |
|
|||
|
try reading the tech doc its about painting plastic its the same process.
documents.php?d=20
_________________ Owning 1 of 84,847 ebII. |
|||
| Top | |
|||
| xr8p200 |
|
||
Age: 39 Posts: 16 Joined: 8th May 2009 Ride: AU II XR8 UTE Pursuit 200 Location: Browns Plains |
Sweet cheers for that will give it a read.
|
||
| Top | |
||
| XRfairmont67 |
|
|||
|
if u want it to last use ther plastic primer, k&h do a 400gm pressure pack for around $12
|
|||
| Top | |
|||
| xr8p200 |
|
||
Age: 39 Posts: 16 Joined: 8th May 2009 Ride: AU II XR8 UTE Pursuit 200 Location: Browns Plains |
elf100capri wrote: if u want it to last use ther plastic primer, k&h do a 400gm pressure pack for around $12 do i just plastic prime the the spots that i rup back to the bar or should i strip the whole thing. please say just the spots needed. |
||
| Top | |
||
| XRfairmont67 |
|
|||
|
pics would help, but u can just use plastic primer in those repaired/rubbed spots and then high fill prime those areas 3 or 4 times to build it up again. u will need to sand back high fill with a block to get rid of the joins in repairs though. make sure u give it a few days to go hard before sanding too, as it will shrink a little and then show up in the tops coats, when finished.
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 92 guests |
