|
| EL2XR8 |
|
|||
|
does anybody know the easiest or only way to remove the peice that's in between the rear bumper and lights? it has the badges on it.
took all srews off and starts to come off but I'd say there must be some spot weld in other areas holding it in? thanks.
_________________ EL II XR8
|
|||
| Top | |
|||
| uglybob |
|
|||
|
theres no welds from memory, but you have to remove the rear bumper?
_________________ R.I.P. Scotty |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
there is a few 10mm nuts on the inside of the beaver panel , behind the trim i think there is a total of 4 .
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| EL2XR8 |
|
|||
|
got the 4 screws out as well as the lights as there is there, it's looser but still not free?
_________________ EL II XR8
|
|||
| Top | |
|||
| MRE-50L |
|
|||
|
so you got the rear bar off and the 4 10mm nuts off from the inside ?
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| EL2XR8 |
|
|||
|
not the bumper, you wouldn't think that would need to come off? would it be hard?
_________________ EL II XR8
|
|||
| Top | |
|||
| MRE-50L |
|
|||
|
cause there is 2 screws under the taillights
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
grr what i ment to say was there 2 screws below the panel under the bar edge
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| fiftyone |
|
|||
|
pull harder. fix what you break when you put it back on
_________________ ** For Sale ** http://www.fordmods.com/ford-parts-for-sale-f17/assorted-e-series-parts-t124697.html |
|||
| Top | |
|||
| Mash85 |
|
||
|
the guys at ftg pulled one of for me without taking the bumper off.
_________________
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 31 guests |
