|
| mk3_1 |
|
|||
|
Hey there..I just got a new exhaust tip for my EL ..but dont know how to remove the existing one... It seems to be like caught on something - is there any trick to removing these - all i seem to be doing is getting a whole bunch of dirt/grime onto my hands!
|
|||
| Top | |
|||
| Leroy |
|
||
|
maybe a self tapper screw in it?
maybe welded on?
_________________ Now driving a Hilux |
||
| Top | |
||
| fordzatmyplace |
|
||
|
is it a aftermarket tip or factory?
_________________ ^^^ What He Said
|
||
| Top | |
||
| mk3_1 |
|
|||
|
Its a tip off an AU..my mate is giving me his cos he just bought one..but we can't work out how to remove it (we're pretty dumb it seems)
|
|||
| Top | |
|||
| fordzatmyplace |
|
||
|
who put it on? a exhuast place, your mate???
_________________ ^^^ What He Said
|
||
| Top | |
||
| mk3_1 |
|
|||
|
Its the factory AU Ghia tip...
|
|||
| Top | |
|||
| fordzatmyplace |
|
||
|
who put it on?
_________________ ^^^ What He Said
|
||
| Top | |
||
| Leroy |
|
||
|
i thought that was part of the pipe?
_________________ Now driving a Hilux |
||
| Top | |
||
| mk3_1 |
|
|||
|
Its a factory fit..so im assuming ford put it on. It doesn't look part of the pipe..it looks like a slip-on job but i just can't figure how to pry it off...it has a few little clip things seem to be caught on the pipe..I was thinking just jamming a flathead screwdriver between the pipe and the tip and prying it loose... any other suggestions?
|
|||
| Top | |
|||
| nannas_ed |
|
|||
|
when i replaced that stock tip on my ghia we tried taping it off with a cold chiesl and a hammer but that didnt work so we cut it of infront of the muffler and welded a new pipe on and obviosly the tip too. only set me back $30 bucks parts and labour at the exhaust shop
_________________
|
|||
| Top | |
|||
| LG |
|
|||
|
mk3_1 wrote: Its a factory fit..so im assuming ford put it on. It doesn't look part of the pipe..it looks like a slip-on job but i just can't figure how to pry it off...it has a few little clip things seem to be caught on the pipe..I was thinking just jamming a flathead screwdriver between the pipe and the tip and prying it loose... any other suggestions?
You'll see that the tip actually has two indents, so the further it goes on, the tighter it will hold. I.e. the bottom of the tip is like this (___/\____/\___) So the two /\, grips onto the exhaust pretty tight. Your gonna need to use a bit of force, maybe use some material so u dont scratch it, otherwise they are only $20-40 or something from Autobahn or Supercheap or wherever.
_________________
|
|||
| Top | |
|||
| madmax |
|
|||
|
Carefully cut a slot down the length of it with a small angle grinder, then it should pull of easily.
_________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 87 guests |
