|
| fordfreak ef |
|
|||
|
ore pics scud! nice waGon.. pics of the whole car.. front/side on.. rear shot from straight behind..
|
|||
| Top | |
|||
| frd906n |
|
||
|
Not Mine, But My Uncles
ba xr8, 18 inch chromes, factory hardlid and spoiler and bonnet couple of pod gauges 5spd manual twin exhuast system, off the shelf tune anyways here some pics  
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
Last edited by frd906n on Thu Dec 03, 2009 10:57 pm, edited 1 time in total. |
||
| Top | |
||
| happydude666 |
|
|||
Age: 34 Posts: 201 Joined: 1st Dec 2008 Ride: BAxr6 mkII, BA xr6, EA Spac Location: Melbourne |
nice ute mate just curios that 12 second run was it in full street trim or did he do things like remove the airbox side headlight, ect?
_________________ Homer- Everytime i try to learn somethign new it pushes out old information! |
|||
| Top | |
|||
| frd906n |
|
||
|
removed
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
Last edited by frd906n on Thu Dec 03, 2009 10:58 pm, edited 1 time in total. |
||
| Top | |
||
| Sharfty |
|
||
|
As you see it's a standard au forte wagon with a dikkie seat in the rear for the kiddies but I have a few photos in my gallary with a few changes mags and some engine mods.
|
||
| Top | |
||
| low_ryda |
|
|||
|
roflmfao @ a 12sec pass in a stock xr with a tune..... he's pissing in your pocket.
turb 6's are more tunable and still won't get a 12 second pass without alot of work. not too mention it's a ute, and a v8 so unless he was connected to the track with a gear drive i would severely doubt it. but just call me a skeptic.
_________________ Not to get technical, but according to chemistry alcohol is a solution. |
|||
| Top | |
|||
| Sharfty |
|
||
|
Well he might be taking the piss but do you know for shure. And if not well we will give him a chance.
|
||
| Top | |
||
| happydude666 |
|
|||
Age: 34 Posts: 201 Joined: 1st Dec 2008 Ride: BAxr6 mkII, BA xr6, EA Spac Location: Melbourne |
{USERNAME} wrote: roflmfao @ a 12sec pass in a stock xr with a tune..... he's pissing in your pocket. turb 6's are more tunable and still won't get a 12 second pass without alot of work. not too mention it's a ute, and a v8 so unless he was connected to the track with a gear drive i would severely doubt it. but just call me a skeptic. I was thinking that but he was pretty vague in his description of mods so i thought gie him a chance to explain....
_________________ Homer- Everytime i try to learn somethign new it pushes out old information! |
|||
| Top | |
|||
| Sharfty |
|
||
|
No probs with what your sayin but he is getting his info off an uncle so as I see it,It might and it might not .
|
||
| Top | |
||
| fourL6 |
|
|||
|
{USERNAME} wrote: No probs with what your sayin but he is getting his info off an uncle so as I see it,It might and it might not . no hes just typically full of s**t... check out his build thread if that isnt enough... latest pics of my AU  
_________________ Was - {DESCRIPTION} |
|||
| Top | |
|||
| Sharfty |
|
||
|
You do have a sweet AU,Once I get a bit of doug I will do some work on the wagin and if I can getting looking good as what I hope Ill stop the wife from driving it LMAO
|
||
| Top | |
||
| frd906n |
|
||
|
no worrys then
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
Last edited by frd906n on Thu Dec 03, 2009 10:56 pm, edited 1 time in total. |
||
| Top | |
||
| frd906n |
|
||
|
who cares about the time, just a time, just posted it up, this thread isnt about that, about the exterior
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| happydude666 |
|
|||
Age: 34 Posts: 201 Joined: 1st Dec 2008 Ride: BAxr6 mkII, BA xr6, EA Spac Location: Melbourne |
New Boot install
{DESCRIPTION} {DESCRIPTION}
_________________ Homer- Everytime i try to learn somethign new it pushes out old information! |
|||
| Top | |
|||
| fordfreak ef |
|
|||
|
tidy boot install happydude...
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 32 guests |
