|
| brad17djr |
|
|||
|
does any 1 know how to stop them from fading i don't have a garage big enuff to put my car in and they keep fading on me please help me
_________________ 2 FOR TURNING & 2 FOR BURNING |
|||
| Top | |
|||
| FAST-XR |
|
|||
|
ive had the same problem, new ones are out of the question because of price...
the thing ive found works best is car wax, takes the top layer off and seals it for a while... ive tried plastic polish and that didnt work. and every other trim detailer available, which is only good till it rains and then then they go pink again! good luck with it...
_________________ 07 BF MKII XR6T |
|||
| Top | |
|||
| brad17djr |
|
|||
|
yer thanks mate i got some leather protecton from work and it only works till it rains too there a pain in the a** how much are new 1's? roughly?
_________________ 2 FOR TURNING & 2 FOR BURNING |
|||
| Top | |
|||
| Leroy |
|
||
|
new ones all round would be hundreds of monies
_________________ Now driving a Hilux |
||
| Top | |
||
| FAST-XR |
|
|||
|
yeah about $700 for a full set, ridiculous!
_________________ 07 BF MKII XR6T |
|||
| Top | |
|||
| Leroy |
|
||
|
you coul i suppose try, sanding and painting
_________________ Now driving a Hilux |
||
| Top | |
||
| brad17djr |
|
|||
|
yer i was even thinking of that lol $700 could work wonders for me lol i think they will just have to be pink lol
_________________ 2 FOR TURNING & 2 FOR BURNING |
|||
| Top | |
|||
| Rapier |
|
||
|
they arent that much i have a near new set somewhere bout 60 bucks a door
|
||
| Top | |
||
| brad17djr |
|
|||
|
but a need 4 of them cause there all buggered has any 1 noticed it's only the side ones that go my front and rear are fine touch wood
_________________ 2 FOR TURNING & 2 FOR BURNING |
|||
| Top | |
|||
| sexyr6 |
|
|||
|
have a look here..
http://cgi.ebay.com.au/FORD-EF-EL-SEDAN-XR6-XR8-RED-BODY-MOULDS-NEW-SET_W0QQitemZ250173099909QQihZ015QQcategoryZ21654QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
_________________
|
|||
| Top | |
|||
| jjohnno |
|
||
|
pretty sure supercheap do them now
just ask for it to be special ordered |
||
| Top | |
||
| brad17djr |
|
|||
|
cool thanks heaps guys there realy starting to piss me off
_________________ 2 FOR TURNING & 2 FOR BURNING |
|||
| Top | |
|||
| GlennBA |
|
|||
|
Why don't you just get them painted in 2 pack. It wouldn't cost that much if you removed and reinstalled them for the panel shop. If you got them done in hot chilli red, the EL XR/AU1 XR red it should match ok.
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
I've just about finished putting a second hand set to my XH - they were pretty weathered, but only cost me $10 for the whole set.
-Wet sand with 320/400 paper to remove weathered surface -polish with a cut and polish for faded paint to bring up a 'low sheen' type finish (you might want to briefly wet sand before this with 600/800 paper to reduce deep scratching) -finish off with a plastic polish If you have to pull the strips off, note the colour of the underside - the above method will bring it back to about 95% of it's original colour. I'm not sure how the weather will affect them, but I'd guess they should only need the occasional going over with plastic polish to maintain them. Don't paint them - I've tried vinyl paint on some damaged strips, and you can tell the difference.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| brad17djr |
|
|||
|
yer the sand looks like the go some 1 sed car wax is good too all u realy gota do is remove the 1st layer and tere will be fresh stuff underneath well i most well give it a shot there fuked already so what can go wrong oh how do u take them off?
_________________ 2 FOR TURNING & 2 FOR BURNING |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 120 guests |
