|
| Lukeyson |
|
|||
|
I'm trying to remove the Mudflaps from the front guards on my BAXR - and do you think I can so much as budge the bloody Fir Tree clips that hold them in?
All the scrivets have come out easy, but not one single Fir Tree has budged. Does anyone have any handy techniques or tools for getting these cheap-a*** bastards out? There's two at the top of the splash shield as well that I haven't even started on. The 4 x on the Mudflap are lucky not to have split on me I've put that much pressure on them from behind with two screwdrivers to get them out - and they haven't moved a bit! I'm aiming to clean out the washer bottle filters (and getting some ideas for other mods based on upgrading my BA single-pump-no-sensor bottle unit with a Territory dual-pump-plus-sensor). It just so happens that I did our Territory today thanks to a blocked windscreen pump filter (the rear pump was fine) and the job was so much easier since there were no bloody fir trees.... Lukeyson. |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
wtf are fir trees? got a pic at all??
_________________ RIP SCOTT |
|||
| Top | |
|||
| Lukeyson |
|
|||
|
Well, if I could ever get them out, I would, yeah.
At least I think they are fir-tree clips - similar to what's holding in the parcel shelf . Lukeyson |
|||
| Top | |
|||
| Lukeyson |
|
|||
|
Nope. Bugger it. I spent another 2 hours on them this morning.
It was just to get in and do a bit of cleaning. When I actually need to get in I'm just going to cut the bastards off and put new ones in. I can't believe how hard they've made it. I'm somewhat dirty about it too. Fir-tree clips are just an incompetent design engineer's fastener if you ask me. Lukeyson |
|||
| Top | |
|||
| data_mine |
|
|||
|
Gimme a screw any day
(lol) 'Fir Tree' clips are those plastic screws, but instead of a thread, the shaft is covered in 'flaps' They push in, and grab, very hard to remove. Commonly used to hold carpet and plastic trim on.
_________________ 1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow |
|||
| Top | |
|||
| Froudey |
|
||
|
get a screw driver in the centre of the clip and hit hard to bust them off just go to fraud and get some more.
_________________ R.I.P Tobias my son. |
||
| Top | |
||
| MRE-50L |
|
|||
|
long nose plyers
get in under the head of the clip and leaver them out
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| OZBMX |
|
|||
|
Hmm, I normally try those f**k with the screw driver appropriate for about minute, if no luck(so 80% of the time), grab a hold of surrounding plastic and yank, if their real buggers in comes a big flathead, and try and lever the two pieces I want apart, eventually they pop out.
_________________ Signature removed by moderator.signature must not exceed 120x500 pixles |
|||
| Top | |
|||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
Froudey wrote: bust them off just go to fraud and get some more.
haha..... i went there once and they wanted 3 bucks EACH clip 
So went to Super Cheap and got them for 1 dollar each, but still a big ripoff |
||
| Top | |
||
| data_mine |
|
|||
|
Find an industrial fastener place, place here in Canberra, does 'em for like $2 for 10.
_________________ 1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow |
|||
| Top | |
|||
| MRE-50L |
|
|||
|
or you could even use the claw end of a hammer and pry out
_________________ Chance Favors The Prepared Mind ! |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
i want a pic of clips! please
_________________ RIP SCOTT |
|||
| Top | |
|||
| data_mine |
|
|||
|
_________________ 1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow |
|||
| Top | |
|||
| Disco Frank |
|
|||
|
ahh those they easy to get out!
cheers datamine just use a pair of side cutters under the head and pull!
_________________ RIP SCOTT |
|||
| Top | |
|||
| aumatt |
|
|||
|
I had to take mine off, in the end I just cut them and bought new ones. Yeah and dont go to ford.
_________________ 2004 Harvest Green XR6
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 17 guests |
