|
| EF 5.0 |
|
||
|
i have a ef fairmont v8
has anyone changed the odometer golbe for a blue led t5 wilst removing the orange filter. so the blue light can shine thru? if so what were the results? regards to all... 
ps i dont want do it and then have look like crap! |
||
| Top | |
||
| TickXR |
|
|||
|
I don't have pics anymore but it looks pretty good
My old XR6 had blue LED's in dash itself as well and you could see couple hotspots but wasn't too bad, if i was to do it with blue LED's again i would sand the underside of the needles removing the orange coat and paint them white so you can see them at night
_________________ If you don't do it whilst your livin, you aint got no bloody chance when your dead!!! |
|||
| Top | |
|||
| XRfairmont67 |
|
|||
|
hi, i have blue leds in my el xr6 dash, i am using ef white needles. i bought mine from jaycar and soldered/fitted them myself. they were 10,000mcd 5mm, brightest i have found. odometer is a little dull but is still readable. cost around $4.00 ea to make. you can buy them premade in autobarn or outbound and elsewhere ,they cost about $7 a pair. i used 12 t5s for dash, trip comp, demist and climate control ignition key lamp and a blue inverted led t10 for my tbar indicator in the console. im happy with the look. to make the leds light spread better i just rubbed scotchbrite over the lenses otherwise it will concentrate the light in the middle.
|
|||
| Top | |
|||
| EF 5.0 |
|
||
|
how do you get the needles of without damaging them?
i've tried just pulling them but they dont want to move! whats the secret? |
||
| Top | |
||
| Kenay |
|
|||
|
i got a knife under them and flicked them up fairly easy to take off
|
|||
| Top | |
|||
| XRfairmont67 |
|
|||
|
can use a fork also. avoid bending the shaft too. make sure you mark where they were pointing to on the side of the faces, to make it easier to refit
|
|||
| Top | |
|||
| blue |
|
|||
|
I used a fork too, just go slow it will come off. I have a blue odometer and it looks awsome(no pics sorry) Had to do it becuse the rest was of the cluster was blue and the orange stood out real bad. Only prob i had was the paper i put in to replace the filter looked s**t it was a grainy and u could seen the texture of the paper, so i replaced it with a bit of transparent blue plastic from a folder/enlope thing i brought from safeway and it looked awsome. I have an EL mont btw
|
|||
| Top | |
|||
| muncher2002 |
|
|||||
|
EF 5.0 wrote: i have a ef fairmont v8 has anyone changed the odometer golbe for a blue led t5 wilst removing the orange filter. so the blue light can shine thru? if so what were the results? regards to all... ps i dont want do it and then have look like crap! i did this to mine i used filters made up of coloured plastic with a blue led i asume it would have looked good but i screwed it back togeather too hard the trip meter come good though Attachment: File comment: whoops
Image0118.jpg [ 250.47 KiB | Viewed 210 times ]
_________________ need a rotisserie for a classic resto 0471525912 Tom |
|||||
| Top | |
|||||
| Who is online |
|---|
Users browsing this forum: No registered users and 63 guests |
