well rightly or wrongly i sent away and recived the "da dashi code"booklet.About the only thing it did was get me into the odo to scroll through the 16 displays,trouble is that what is described in the booklet doesnt match what shows on the screen.Does anyone know what the explanations or titles are for the 16 displays that come up,i can figure out a couple but it would be good to have the whole list.Ihave a GLi 95 EF that i put a Fairmont dash into,would this give a different reading...also after putting the dash in and hooking up the low water level sensor, the light stays on and occasionally goes off and on, despite the bottle being full...suggestions......thanks.......

have a look through the technical docs on this site, theres lots of info including diagnostic mode

http://www.fordmods.com/forums/documents.php?doc=12

most of the 16 displays have been accounted for, some have not.

as for the low water sensor, assuming everything is hooked up properly, the float part of the sensor may be full of water or covered in sludge.. probably best the pull it out and test it manually?


-mitch

bad connection !!

^^^ bad connection change sensor